The lithium ion (Li-ion) battery industry has been growing exponentially since its initial inception in the late 20th century. As battery materials evolve, the applications for Li-ion batteries have become even more diverse. To date, the main source of Li-ion battery use varies from consumer portable electronics to electric/hybrid electric vehicles. However, even with the continued rise of Liion battery development and commercialization, the recycling industry is lagging; approximately 95% of Li-ion batteries are landfilled instead of recycled upon reaching end of life. Industrialized recycling processes are limited and only capable of recovering secondary raw materials, not suitable for direct reuse in new batteries. Most technologies are also reliant on high concentrations of cobalt to be profitable, and intense battery sortation is necessary prior to processing. For this reason, it is critical that a new recycling process be commercialized that is capable of recovering more valuable materials at a higher efficiency. A new technology has been developed by the researchers at Worcester Polytechnic Institute which is capable of recovering LiNi x Mn y Co z O 2 cathode material from a hydrometallurgical process, making the recycling system as a whole more economically viable. By implementing a flexible recycling system that is closed-loop, recycling of Li-ion batteries will become more prevalent saving millions of pounds of batteries from entering the waste stream each year.

The crystal structure and electrochemical properties of LiNi1/3Mn1/3Co1/3O2 (NMC) synthesized from a lithium ion battery recovery stream have been studied previously. In this report, we study the Cu impurity effects on NMC in detail. The difference in crystal structures and electrochemical properties were examined for pure and copper impurity included products. Scanning electron microscopy figures show that the precursor particles of NMC are slightly bigger than that of NMC with copper impurity. After undergoing 150 cycles at 2C, X-ray diffraction refinements results show that the lattice parameters for impurity containing NMC and pure NMC change to different extents. Furthermore, due to the minor change of lattice parameters, copper-containing NMC offers a more stable capacity retention compared to pure NMC.

No abstract

No abstract

Toxic metal reduction is at the forefront of many design considerations today; additive manufacturing has the ability to combine materials in ways other traditional processes cannot and has the potential to offer unique solutions to reduce hazardous materials needed in manufacturing. Tungsten carbide (WC) has been used as a substitute in wear applications where toxic processes are traditionally utilized, but it can be difficult to deposit high-quality, hard and durable coatings. Additionally, there is a need to apply WC coatings on surfaces not feasible with the current processes. Cold spray, a solid-state directed powder deposition process, is effective at depositing carbides, though powders must be thoughtfully designed to achieve desired mechanical properties. In this study, WC was investigated as a hard chrome alternative for wear applications. Various blend ratios and preparation methods were evaluated as feedstock powder and then sprayed. Feedstock characteristics were compared to cold spray performance. Cold spray consolidations were evaluated for coating porosity and hardness. It was found that when powder make-up and composition were optimized, a high-hardness and low-porosity material was made that will contribute to the reduction in dependency of Cr in wear-facing components.