The results of this study suggest that short-term postoperative morbidity may be reduced in dogs receiving arthroscopic joint surgery with a limited approach for stifle stabilization as compared with a traditional open arthrotomy technique.

Use of a patellar groove replacement prosthesis has the potential to decrease the lameness associated with severe femoro-patellar arthritis, to improve patellar stability, and to correct the alignment of the extensor mechanism.

Objective: The purpose of the study reported here was to describe variables affecting thigh girth measurements preoperatively and 2 weeks after surgical stabilization of the stifle and to examine inter- and intra-observer reliability.Animals: Ten hound-type dogs with experimental, unilateral, cranial cruciate ligament transection, and surgical stabilization.Procedures: Dogs were placed in lateral recumbency for measurements of thigh circumference after the stifle was placed in flexed (F), estimated standing (S), and extended (E) positions. Measurements were made at 50 and 70% of thigh length (TL), with hair unclipped and then clipped prior to surgery, before and 2 weeks after cruciate ligament transection and stifle stabilization, and with and without sedation. A spring tension measuring tape was used to determine thigh girth that allowed a consistent amount of end-tension to be applied to the tape. All measurements were made by two blinded individuals in triplicate, data were recorded for each set of measurements and the mean of the three measurements for each condition was used for analysis.Results: Thigh girth was significantly greater at the more proximal site of 50% TL (36.7 ± 2.6 cm) when compared to the 70% TL (31.7 ± 2.7 cm) (P = 0.001). Sedation did not significantly affect thigh girth at any stifle position at the 70% and 50% TL. Although there were no differences in thigh circumference between the flexion and standing positions at 50% TL (F 38.2 ± 2.8 cm, S 38.1 ± 2.9 cm) and 70% TL (F 33.6 ± 1.6 cm; S 33.6 ± 1.8 cm), full extension of the stifle resulted in significantly less thigh girth (50% TL 36.6 ± 2.6 cm, P = 0.006; 70% TL 31.7 ± 2.6 cm, P = 0.006). Significant decreases in thigh girth were seen after surgery in all limb positions at both measurement sites. The highest correlations between Observer 1 (OB1) and Observer 2 (OB2) with least differences in measurements were with the stifle in the extended position. Agreement between two observers using standard measuring technique was significant at both the 50% (OB1: 34.10 ± 2.93 cm, OB2: 34.08 ± 2.65 cm, P = 0.007, ICC = 0.984) and 70% (OB1: 29.89 ± 2.43 cm, OB2: 30.04 ± 2.30 cm, P = 0.004, ICC = 0.981) TL positions with the stifle placed in extended position.Conclusion and Clinical Importance: Thigh girth measurement may be useful as an outcome measure when appropriate measuring technique is used. It is recommended that thigh girth be obtained at a distance of 70% thigh length, with the leg in an extended position while in lateral recumbency, and the dog relaxed or under sedation. Further studies should be performed in a variety of clinical situations.

Unilateral triple pelvic osteotomy was performed with three variations in technique on canine cadaver pelves. The following variables were studied: the angle of the ilial osteotomy (perpendicular to the long axis of the ilium and 10 degrees, 20 degrees, and 30 degrees off perpendicular); the degree of axial rotation (20 degrees, 30 degrees, and 45 degrees); and the type of fixation (canine pelvic osteotomy plate [CPOP] or a 2.7-mm dynamic compression plate [DCP]). Structural changes measured were the pelvic inlet and acetabular area, interischiatic tuberosity distance, and degree of acetabular version. Means and standard error of the means were determined for all pelvic measurements and were analyzed by three-way analysis of variance (P < .05). As the axial rotation increased from 20 degrees to 45 degrees an ilial osteotomy angled 10 degrees, 20 degrees, or 30 degrees resulted in a significantly greater decrease in the pelvic inlet area and significantly less deviation of the interischiatic tuberosity distance and degree of acetabular version from normal than an osteotomy directed perpendicular to the long axis of the ilium. Compared with the CPOP, as the axial rotation increased from 20 degrees to 45 degrees, the DCP resulted in a significantly greater decrease in the pelvic inlet area, an increase in the interischiatic tuberosity distance and degree of acetabular version, and less of an increase in the acetabular area. The results of this study suggest that to maximize dorsal acetabular coverage, while minimizing disruption of normal pelvic architecture, a CPOP and an ilial osteotomy angled 10 degrees to 30 degrees are preferred for all degrees of axial rotation.

No abstract