Acquired von Willebrand Syndrome (AvWS) is known as a frequent bleeding complication in patients on ventricular assist device (VAD) support. Clinicians demand that the requirements for VADs with regard to hemocompatibility should also include low susceptibility for AvWS. Clinical AvWS diagnosis is known to be a complex, high-price, and time-consuming analysis. This article investigates an easy-to-handle, time-efficient, and inexpensive method for comparative AvWS investigations in vitro. Von Willebrand Factor activity level (vWF:Ac) and von Willebrand Factor antigen level (vWF:Ag) were chosen from the complete set of clinically established parameters. Blood plasma (human and porcine) was exposed to an inhomogeneous shear field in a shear-inducing test set up for up to 4 h. Plasma samples were drawn after different load periods and analyzed for vWF:Ac and vWF:Ag. vWF multimer analysis of selected samples were used as reference for determination of high molecular weight multimer (HMWM) loss. AvWS was detected after 20 min of shear load via vWF:Ac/vWF:Ag ratio and multimer analysis. A good correlation between the vWF:Ac/vWF:Ag ratio and HMWM loss (multimer analysis) was found for human plasma. AvWS characteristics of human and porcine plasma for analyzed samples were comparable. A correlation between vWF:Ac/vWF:Ag ratio and HMWM in porcine plasma could not be found. Results gained in this study indicate that vWF:Ac/vWF:Ag ratio is sensitive enough for comparative AvWS investigations in vitro with human blood. The applicability of the method suggested in this article for AvWS characterization in porcine blood needs to be investigated in further studies. The selection of analysis kits promises a less cost- and labor-intensive, time-consuming, and complex method for comparative AvWS investigations in vitro compared with AvWS diagnosis in patients.

In the development of new hemocompatible biomaterials, surface modification appears to be a suitable method in order to reduce the thrombogenetic potential of such materials. In this study, polycarbonate-urethane (PCU) tubes with different surface microstructures to be used for aortic heart valve models were investigated with regard to the thrombogenicity. The surface structures were produced by using a centrifugal casting process for manufacturing PCU tubes with defined casting mold surfaces which are conferred to the PCU surface during the process. Tubes with different structures defined by altering groove widths were cut into films and investigated under dynamic flow conditions in contact with porcine blood. The analysis was carried out by laser scanning microscopy which allowed for counting various morphological types of platelets with regard to the grade of activation. The comparison between plain and shaped PCU samples showed that the surface topography led to a decline of the activation of the coagulation cascade and thus to the reduction of the fibrin synthesis. Comparing different types of structures revealed that smooth structures with a small groove width (d ~ 3 μm) showed less platelet activation as well as less adhesion in contrast to a distinct wave structure (d ~ 90 μm). These results prove surface modification of polymer biomaterials to be a suitable method for reducing thrombogenicity and hence give reason for further alterations and improvements.

ObjectivesAcquired von Willebrand syndrome (AvWS) is associated with postoperative bleeding complications in patients with continuous flow left ventricular assist devices (CF-LVADs). The aim of this study is to analyze the perioperative vWF profile comparing an axial pump (HMII) to a centrifugal pump (HVAD) regarding the correlation between perioperative occurrence of AvWS, early- and late-postoperative bleeding events.MethodsFrom July 2013 until March 2015 blood samples of 33 patients (12 HMII/ 8 HVAD/ 13 controls) were prospectively collected at 12 different time points and analyzed for the vWF antigen (vWF:Ag), its activity (vWF:Ac) and the vWF:Ac/vWF:Ag-ratio (vWF:ratio). The follow up period for postoperative bleeding events was from July 2013 until July 2016.ResultsPostoperatively, there was no difference in the vWF-profile between HVAD and HMII groups. However, a subgroup of patients already had significantly lower vWF:ratios preoperatively. Postoperatively, both CF-LVAD groups presented significantly lower vWF:ratios compared to the control group. Bleeding events per patient-year did not differ between the two groups (HMII vs. HVAD: 0.67 vs. 0.85, p = 0.685). We detected a correlation between vWF:ratio <0.7at LVAD-start (r = -0.583, p = 0.006) or at the end of surgery (r = -0.461, p = 0.035) and the occurrence of pericardial tamponade. In the control group, the drop in both vWF:Ag and vWF:Ac recovered immediately postoperatively above preoperative values.ConclusionA subgroup of patients with end-stage heart failure already suffers AvWS preoperatively. In both CF-LVAD groups, AvWS begins immediately after surgery. Intraoperative vWF:ratios <0.7 correlate with higher incidences of pericardial tamponade and re-operation. The presumably dilutive effect of the heart lung machine on vWF vanishes immediately at the end of surgery, possibly as part of an acute-phase response.

BackgroundClinical registries provide information on the process of care and patient outcomes, with the potential to improve the quality of patient care. A large Dutch national acute coronary syndrome (ACS) registry is currently lacking. Recently, we initiated the National Cardiovascular Database Registry (NCDR) for ACS in the Netherlands. The purpose of this study was to assess the NCDR ACS registry on feasibility and data completeness during a pilot phase of four snapshot weeks.MethodsBetween 2013 and 2015, we invited all hospitals in the Netherlands to record a predefined dataset for every patient that was admitted to their hospital with ST-segment elevation myocardial infarction (STEMI). Data were entered in an online case report form. All patient-specific data were encrypted to ensure privacy.ResultsA total of 392 patients were registered in 35 centres. The mean age of the patients was 64 years (SD 13); 8% of patients presented with signs of cardiogenic shock and 11% with an out-of-hospital cardiac arrest. The median time from first medical contact to percutaneous coronary intervention (PCI) was 75 min (IQR 51–108) and this was significantly longer for patients who presented at a non-PCI centre or to a primary care physician. In-hospital and 30-day mortality rates were 5.2% and 7.8%, respectively. The amount of completeness varied, with improved completeness over time.ConclusionThis report shows that a Dutch ACS registry is feasible with respect to STEMI patients. Data completeness, however, was suboptimal. Improved data completeness is warranted for the future.

The hemocompatibility of blood-contacting medical devices remains one of the major challenges in medical device development. A common tool for the analysis of adherent and activated platelets on materials following in vitro tests is microscopy. Currently, most researchers develop their own routines, resulting in numerous different methods that are applied. The majority of those (semi-)manual methods analyze only a very small fraction of the material surface (<1%), which neglects the inhomogeneity of platelet distribution and makes results hardly comparable. Within this study, we examined the relation between the fraction of analyzed sample area and the platelet adhesion result. By means of image segmentation and machine learning algorithms, 103 100 microscopy images were analyzed automatically. We discovered a crucial impact of the analyzed surface fraction and thus a misrepresentation of a surface's platelet adhesion unless up to 40% of the sample surface is analyzed. These findings underline the necessity of standardization in the field of in vitro hemocompatibility tests and analyses in particular and provide a first basis to make future tests more reliable and comparable.