Cyanide fishing, where a solution of sodium or potassium cyanide is used to stun reef fish for easy capture for the marine aquarium and live fish food trades, continues to be pervasive despite being illegal in many countries and destructive to coral reef ecosystems. Currently, there is no easy, reliable and universally accepted method to detect if a fish has been exposed to cyanide during the capture process. A promising non-invasive technique for detecting thiocyanate ions, the metabolic byproduct excreted by exposed fish, has been reported in the literature. In an effort to validate this method, four cyanide exposure studies on Amphiprion ocellaris (common clownfish) were carried out over three years. Fish were either exposed to the same (25 ppm) or twice the concentration (50 ppm) as the previsouly published method. Over 100 water samples of fish exposed to cyanide were analyzed by reverse phase HPLC with a C30 column treated with polyethylene glycol and UV detector operating at 220 nm. No thiocyanate was detected beyond the analytical standards and positive controls prepared in seawater. As an alternate means of detecting thiocyanate, water samples and thiocyanate standards from these exposures were derivatized with monobromobimane (MBB) for LC-MS/MS analysis. Thiocyanate was detected in standards with concentrations as low as 0.6 μg/L and quantified to 1 μg/L, but thiocyanate could not be detected in any of the water samples from fish exposed to cyanide with this method either, confirming the HPLC results. Further, we calculated both the mass balance of thiocyanate and the resultant plausible dosage of cyanide from the data reported in the previously published method. These calculations, along with the known lethal dosage of cyanide, further suggests that the detection of thiocyanate in aquarium water is not a viable method for assessing fish exposure to cyanide.

The field of metabolomics generally lacks standardized methods for the preparation of samples prior to analysis. This is especially true for metabolomics of reef-building corals, where the handful of studies that were published employ a range of sample preparation protocols. The utilization of metabolomics may prove essential in understanding coral biology in the face of increasing environmental threats, and an optimized method for preparing coral samples for metabolomics analysis would aid this cause. The current study evaluates three important steps during sample processing of stony corals: (i) metabolite extraction, (ii) metabolism preservation, and (iii) subsampling. Results indicate that a modified Bligh and Dyer extraction is more reproducible across multiple coral species compared to methyl tert-butyl ether and methanol extractions, while a methanol extraction is superior for feature detection. Additionally, few differences were detected between spectra from frozen or lyophilized coral samples. Finally, extraction of entire coral nubbins increased feature detection, but decreased throughput and was more susceptible to subsampling error compared to a novel tissue powder subsampling method. Overall, we recommend the use of a modified Bligh and Dyer extraction, lyophilized samples, and the analysis of brushed tissue powder for the preparation of reef-building coral samples for 1H NMR metabolomics.

No abstract