The results of an experimental investigation on the effect of vortex generators, in the form of small tabs at the nozzle exit on the evolution of a jet, are reported in this paper. Primarily tabs of triangular shape are considered, and the effect is studied up to a jet Mach number of 1.8. Each tab is found to produce a dominant pair of counter-rotating streamwise vortices having a sense of rotation opposite to that expected from the wrapping of the boundary layer. This results in an inward indentation of the mixing layer into the core of the jet. A triangular-shaped tab with its apex leaning downstream, referred to as a delta tab, is found to be the most effective in producing such vortices, with a consequential large influence on the overall jet evolution. Two delta tabs, spaced 180° apart, completely bifurcate the jet. Four delta tabs stretch the mixing layer into four ‘‘fingers,’’ resulting in a significant increase in the jet mixing downstream. For six delta tabs the mixing layer distortion settles back to a three finger configuration through an interaction of the streamwise vortices. The tabs are found to be equally effective in jets with turbulent or laminar initial boundary layers. Two sources of streamwise vorticity are postulated for the flow under consideration. One is the upstream ‘‘pressure hill,’’ generated by the tab, which constitutes the main contributor of vorticity to the dominant pair. Another is due to vortex filaments shed from the sides of the tab and reoriented downstream by the mean shear of the mixing layer. Depending on the orientation of the tab, the latter source can produce a vortex pair having a sense of rotation opposite to that of the dominant pair. In the case of the delta tab, vorticity from the two sources add, explaining the strong effect in that configuration.

No abstract

Hot-wire and flow-visualization studies have been carried out in three air jets subjected to pure-tone acoustic excitation, and the instability, vortex roll-up and transition as well as jet response to the controlled excitation have been investigated. The centreline fluctuation intensity can be enhanced by inducing stable vortex pairing to a level much higher than even that at the ‘preferred mode’, but can also be suppressed below the unexcited level under certain conditions of excitation. The conditions most favourable to vortex pairing were determined as a function of the excitation Strouhal number, the Reynolds number (ReD), and the initial shear-layer state, i.e. laminar or turbulent. It is shown that the rolled-up vortex rings undergo pairing under two distinct conditions of excitation: ‘the shear layer mode’ when the Strouhal number based on the initial shear-layer momentum thickness (Stθ) is about 0·012, and ‘the jet column mode’ when the Strouhal number based on the jet diameter (StD) is about 0·85. The former involves pairing of the near-exit thin vortex rings when the initial boundary layer is laminar, irrespective of the value of StD. The latter involves pairing of the thick vortex rings at x/D ≅ 1·75, irrespective of Stθ or whether the initial boundary layer is laminar or turbulent. For laminar exit boundary layer, pairing is found to be stable, i.e., occurring regularly in space and time, for ReD < 5 × 104, but becomes intermittent with increasing ReD or fluctuation intensity in the initial boundary layer.The trajectories of the vortex centres and their convection velocities during a pairing event have been recorded through phase-locked measurements. In the presence of stable vortex pairing, the time average profiles of fluctuation intensities and Reynolds stress show noticeable deviations from those in the unexcited jet. The vortex pairing phenomenon produce considerably larger excursions of the $\widetilde{uv}(t)$ signal than the time-average Reynolds stress reveals, suggesting that only certain phases of the pairing process may be important in entrainment, and production of Reynolds stress and jet noise.

The effect of vortex generators, in the form of small tabs projecting normally into the flow at the nozzle exit, on the characteristics of an axisymmetric jet is investigated experimentally over the jet Mach number range of 0.3-1.81. The tabs eliminate screech noise from supersonic jets and alter the shock structure drastically. They distort the jet cross section and increase the jet spread rate significantly. The distortion produced is essentially the same at subsonic and underexpanded supersonic conditions. Thus, the underlying mechanism must be independent of compressibility effects. A tab with a height as small as 2% of the jet diameter, but larger than the efflux boundary-layer thickness, is found to produce a significant effect. Flow visualization reveals that each tab introduces an "indentation" into the high speed side of the shear layer via the action of streamwise vortices. These vortices are inferred to be of the "trailing vortex" type rather than of the "necklace vortex" type. It is apparent that a substantial pressure differential must exist between the upstream and the downstream sides of the tab to effectively produce these trailing vortices. This explains why the tabs are ineffective in the overexpanded flow, as in that case an adverse pressure gradient exists near the nozzle exit which reduces the pressure differential produced by the tab.

The effects of vortex generators and periodic excitation on vorticity dynamics and the phenomenon of axis switching in a free asymmetric jet are studied experimentally. Most of the data reported are for a 3:1 rectangular jet at a Reynolds number of 450 000 and a Mach number of 0.31. The vortex generators are in the form of ‘delta tabs’, triangular-shaped protrusions into the flow, placed at the nozzle exit. With suitable placement of the tabs, axis switching could be either stopped or augmented. Two mechanisms are identified governing the phenomenon. One, as described by previous researchers, is due to the difference in induced velocities for different segments of a rolled-up azimuthal vortical structure. The other is due to the induced velocities of streamwise vortex pairs in the flow. While the former mechanism, referred to here as the ωθ-dynamics, is responsible for a rapid axis switching in periodically forced jets, e.g. screeching supersonic jets, the effect of the tabs is governed mainly by the latter mechanism, referred to as the ωx-dynamics. Both dynamics can be active in a natural asymmetric jet; the tendency for axis switching caused by the ωθ-dynamics may be, depending on the streamwise vorticity distribution, either resisted or enhanced by the ωx-dynamics. While this simple framework qualitatively explains the various observations made on axis switching, mechanisms actually in play may be much more complex. The two dynamics are not independent as the flow field is replete with both azimuthal and streamwise vortical structures which continually interact. Phase-averaged measurements for a periodically forced case, over a volume of the flow field, are carried out in an effort to gain insight into the dynamics of these vortical structures. The results are used to examine such processes as the reorientation of the azimuthal vortices, the resultant evolution of streamwise vortex pairs, as well as the redistribution of streamwise vortices originating from secondary flow within the nozzle.