Measuring a quantum system can randomly perturb its state. The strength and nature of this back-action depend on the quantity that is measured. In a partial measurement performed by an ideal apparatus, quantum physics predicts that the system remains in a pure state whose evolution can be tracked perfectly from the measurement record. We demonstrated this property using a superconducting qubit dispersively coupled to a cavity traversed by a microwave signal. The back-action on the qubit state of a single measurement of both signal quadratures was observed and shown to produce a stochastic operation whose action is determined by the measurement result. This accurate monitoring of a qubit state is an essential prerequisite for measurement-based feedback control of quantum systems.

Owing to the low-loss propagation of electromagnetic signals in superconductors, Josephson junctions constitute ideal building blocks for quantum memories, amplifiers, detectors and high-speed processing units, operating over a wide band of microwave frequencies. Nevertheless, although transport in superconducting wires is perfectly lossless for direct current, transport of radio-frequency signals can be dissipative in the presence of quasiparticle excitations above the superconducting gap. Moreover, the exact mechanism of this dissipation in Josephson junctions has never been fully resolved experimentally. In particular, Josephson's key theoretical prediction that quasiparticle dissipation should vanish in transport through a junction when the phase difference across the junction is π (ref. 2) has never been observed. This subtle effect can be understood as resulting from the destructive interference of two separate dissipative channels involving electron-like and hole-like quasiparticles. Here we report the experimental observation of this quantum coherent suppression of quasiparticle dissipation across a Josephson junction. As the average phase bias across the junction is swept through π, we measure an increase of more than one order of magnitude in the energy relaxation time of a superconducting artificial atom. This striking suppression of dissipation, despite the presence of lossy quasiparticle excitations above the superconducting gap, provides a powerful tool for minimizing decoherence in quantum electronic systems and could be directly exploited in quantum information experiments with superconducting quantum bits.

Qubit reset is crucial at the start of and during quantum information algorithms. We present the experimental demonstration of a practical method to force qubits into their ground state, based on driving appropriate qubit and cavity transitions. Our protocol, called the double drive reset of population, is tested on a superconducting transmon qubit in a three-dimensional cavity. Using a new method for measuring population, we show that we can prepare the ground state with a fidelity of at least 99.5% in less than 3 μs; faster times and higher fidelity are predicted upon parameter optimization.

Applications in quantum information processing and photon detectors are stimulating a race to produce the highest possible quality factor on-chip superconducting microwave resonators. We have tested the surface-dominated loss hypothesis by systematically studying the role of geometrical parameters on the internal quality factors of compact resonators patterned in Nb on sapphire. Their single-photon internal quality factors were found to increase with the distance between capacitor fingers, the width of the capacitor fingers, and the resonator impedance. Quality factors were improved from 210,000 to 500,000 at T = 200 mK. All of these results are consistent with our starting hypothesis.

No abstract