This study aimed to develop printable calcium magnesium phosphate pastes that harden by immersion in ammonium phosphate solution post-printing. Besides the main mineral compound, biocompatible ceramic, magnesium oxide and hydroxypropylmethylcellulose (HPMC) were the crucial components. Two pastes with different powder to liquid ratios of 1.35 g/mL and 1.93 g/mL were characterized regarding their rheological properties. Here, ageing over the course of 24 h showed an increase in viscosity and extrusion force, which was attributed to structural changes in HPMC as well as the formation of magnesium hydroxide by hydration of MgO. The pastes enabled printing of porous scaffolds with good dimensional stability and enabled a setting reaction to struvite when immersed in ammonium phosphate solution. Mechanical performance under compression was approx. 8–20 MPa as a monolithic structure and 1.6–3.0 MPa for printed macroporous scaffolds, depending on parameters such as powder to liquid ratio, ageing time, strand thickness and distance.

Improper ferroelectrics are described by two order parameters: a primary one, driving a transition to long-range distortive, magnetic, or otherwise nonelectric order, and the electric polarization, which is induced by the primary order parameter as a secondary, complementary effect. Using low-temperature scanning probe microscopy, we show that improper ferroelectric domains in YMnO 3 can be locally switched by electric field poling. However, subsequent temperature changes restore the as-grown domain structure as determined by the primary lattice distortion. The backswitching is explained by uncompensated bound charges occurring at the newly written domain walls due to the lack of mobile screening charges at low temperature. Thus, the polarization of improper ferroelectrics is in many ways subject to the same electrostatics as in their proper counterparts, yet complemented by additional functionalities arising from the primary order parameter. Tailoring the complex interplay between primary order parameter, polarization, and electrostatics is therefore likely to result in novel functionalities specific to improper ferroelectrics.

Digital light processing (DLP) enables the fabrication of complex 3D structures based on a photopolymerizable resin usually containing a photo initiator and an UV or photo absorber. The resin and thus the final properties of the printed structures can be adjusted by adding fillers like bioceramic powders relevant for bone‐regeneration applications. Herein, a water‐based and biocompatible poly(ethylene glycol diacrylate) (PEGDA) resin containing the photo initiator lithium‐phenyl‐2,4,6‐trimethylbenzoylphosphinate (LAP) enables the production of 3D structures via DLP. The addition of calcium magnesium phosphate cement (CMPC) powder, acting as photo absorber, leads to higher accuracy of the final structures. After curing the printed construct in a diammonium–hydrogen phosphate (DAHP) bath for hardening, the resulting mechanical properties can be adjusted without post‐process sintering. Solid loading of up to 40 wt% CMPC powder is possible, and the resins are investigated regarding their rheological behavior and printability. The resulting constructs are analyzed in respect to their surface morphology using scanning electron microscope (SEM), porosity, phase composition using X‐ray diffraction (XRD) methods, as well as mechanical properties influenced by the hardening process using DAHP for different durations.