Hypersaline brines are of growing environmental importance but are technologically under-served by today's desalination methods. Temperature swing solvent extraction (TSSE) is a radically different desalination technology that is membrane-less and not based on evaporative phase change. TSSE utilizes lowtemperature heat and a low-polarity solvent with temperature-dependent water solubility for the selective extraction of water over salt from saline feeds. This study demonstrates TSSE desalination of high-salinity brines simulated by NaCl solutions with three amine solvents: diisopropylamine (DIPA), N-ethylcyclohexylamine (ECHA), and N,N-dimethylcyclohexylamine (DMCHA). We show that TSSE can desalinate brines with salinities as high as ≈234000 ppm total dissolved solids (i.e., 4.0 M NaCl) and achieve salt removals up to 98.4%. Among the solvents, DIPA exhibited the highest water extraction efficiency whereas ECHA and DMCHA produced water with the lowest salt content and solvent residue content, respectively. Lastly, a high water recovery of >50% was demonstrated for TSSE desalination of 1.5 M NaCl brine using DIPA in semibatch experiments with multiple extraction cycles. This study underscores the unique capabilities of TSSE for the desalination of hypersaline brines.

In this work, we demonstrate a 3-dimensional graphene oxide (3D GO) stalk that operates near the capillary wicking limit to achieve an evaporation flux of 34.7 kg m −2 h −1 under 1 sun conditions (1 kW/m 2 ). This flux represents nearly a 100 times enhancement over a conventional solar evaporation pond. Interfacial solar evaporation traditionally uses 2D evaporators to vaporize water using sunlight, but their low evaporative water flux limits their practical applicability for desalination. Some recent studies using 3D evaporators demonstrate potential for more efficient water transfer, but the flux improvement has been marginal because of a low evaporation area index (EAI), which is defined as the ratio of the total evaporative surface area to the projected ground area. By using a 3D GO stalk with an ultrahigh EAI of 70, we achieved nearly a 20-fold enhancement over a 2D GO evaporator. The 3D GO stalk also exhibited additional advantages including omnidirectional sunlight utilization, a high evaporation flux under dark conditions from more efficient utilization of ambient heating, a dramatic increase of the evaporation rate by introducing wind, and scaling resistance in evaporating brines with a salt content of up to 17.5 wt %. This performance makes the 3D GO stalk well suited for the development of a low-cost, reduced footprint technology for zero liquid discharge in brine management applications.

No abstract

No abstract

No abstract