Quantifying fluorescent compounds in turbid media such as tissue is made difficult by the effects of multiple scattering and absorption of the excitation and emission light. The approach that we used was to measure fluorescence using a single 200-microm optical fiber as both the illumination source and the detector. Fluorescence of aluminum phthalocyanine tetrasulfonate (AlPcS4) was measured over a wide range of fluorophore concentrations and optical properties in tissue-simulating phantoms. A root-mean-square accuracy of 10.6% in AlPcS4 concentration was attainable when fluorescence was measured either interstitially or at the phantom surface. The individual effects of scattering, absorption, and the scattering phase function on the fluorescence signal were also studied by experiments and Monte Carlo simulations.

Measurement of the concentration of fluorescent compounds in turbid media is difficult because the absorption and multiple scattering of excitation and emission of light has a large effect on the detected fluorescence. For surface measurements with optical fibers we demonstrate by experiments and numerical simulation that this effect can be minimized by measurement of the fluorescence at one source-detector distance, the diffusely reflected excitation light at a second distance, and with the ratio of these two signals as an indicator of fluorophore concentration. For optical properties typical of soft tissue in the red and the near infrared the optimum performance is obtained by measurement of fluorescence at 0.65 mm and reflectance at 1.35 mm. This choice reduces the rms error in fluorophore concentration to 14.6% over a wide range of absorption and scattering coefficients.

This study compares the photosensitizer concentration measured noninvasively in vivo by diffuse reflectance spectroscopy with the results of postmortem tissue solubilization and fluorometric assay. The reflectance spectrometer consists of a fiber optic surface probe, spectrometer and charge-coupled device (CCD) array detector. The surface probe has eight detection fibers separated from the light source fiber by distances ranging from 0.85 to 10 mm. The imaging spectrometer disperses the light from each detector fiber onto the two-dimensional CCD array, while maintaining spatial separation of each individual spectrum. A single exposure of the CCD therefore captures the reflectance spectrum ar eight distances and over a range of 300 nm. From the spectra, the tissue's optical scattering and absorption coefficients are determined using a diffusion model of light propagation. Changes in the tissue absorption are used to estimate the photosensitizer concentration. Normal New Zealand White rabbits were injected with aluminum phthalocyanine tetrasulfonate (AlPcS4) and probe measurements made 24 h after injection on the dorsal skin, on muscle after surgically turning the skin back and on liver. For skin, the noninvasive estimate to proportional to the true concentration but low by a factor of 3. Based on Monte Carlo modeling of multilayered systems, this underestimate is attributed to the layered structure of the skin and nonuniform AlPcS4 distribution. A comparison of the noninvasive concentration estimates to the postmortem assay results finds good agreement for liver tissue even though application of the diffusion model is not strictly justified.

No abstract