A virtualization layer makes it possible to compose multiple functionalities on a multi-core processor with minimum modifications of OS kernels and applications. A multi-core processor is a good candidate to compose various software independently developed for dedicated processors into one multi-core processor to reduce both the hardware and development cost. In this paper, we present SPUMONE, which is a virtualization layer suitable for developing multi-core processor based-information appliances. I IntroductionMulti-core processors are being increasingly adopted for embedded systems because they improve performance, power consumption and lower development cost. Composing multiple operating systems on a multi-core processor enhances the reusability of software when developing rich functional information appliances. Multiple OS environments enable the product to use two versions of an operating system at the same time. In order to build multiple OS environments, a virtualization layer specialized for embedded systems is necessary 1 , since most of processors for embedded systems support only two protection levels, and there is no hardware support for virtualization. In traditional approaches, an OS kernel runs at the user level to isolate the respective OS kernels to increase reliability, but this approach requires heavy modifications to the guest OSes if there is no proper hardware virtualization support that rarely exists in embedded systems. Therefore existing virtualization solutions are not preferred by the embedded system industry.In [1], Armand and Gien present several requirements for a virtualization layer to be suitable for embedded systems:i.It should run an existing operating system and its supported applications in a virtualized environment, such that modifications required to the operating system are minimized (ideally none), and performance overhead is as low as possible. ii. It should be straightforward to move from one version of an operating system to another one; this is especially important to keep up with frequent Linux evolutions. iii. It should reuse native device drivers from their existing execution environments with no modification. iv. It should support existing legacy often real-time 1 Our virtualization layer can used for various embedded systems, but our current main focus is information appliances.operating systems and their applications while guaranteeing their deterministic real-time behavior.Our project is developing SPUMONE, which is a virtualization layer for multi-core processor-based embedded systems. SPUMONE assumes to use an SMP(Symmetric Multiprocessing)-based multi-core processor, and each core has a core-local memory. Thus, it is easy to share code and data from all cores, but each core can keep some code and data secretly in a core-local memory. SPUMONE uses the characteristics to implement the spatial isolation. SPUMONE satisfies the above requirements, and currently focuses on achieving the following four goals.i.Mapping of virtual cores on physical cores dynamically ...