Traumatic brain injury caused by explosive or blast events is traditionally divided into four phases: primary, secondary, tertiary, and quaternary blast injury. These phases of blast-induced traumatic brain injury (bTBI) are biomechanically distinct and can be modeled in both in vivo and in vitro systems. The primary bTBI injury phase represents the response of brain tissue to the initial blast wave. Among the four phases of bTBI, there is a remarkable paucity of information about the cause of primary bTBI. On the other hand, 30 years of research on the medical application of shockwaves (SW) has given us insight into the mechanisms of tissue and cellular damage in bTBI, including both air-mediated and underwater SW sources. From a basic physics perspective, the typical blast wave consists of a lead SW followed by supersonic flow. The resultant tissue injury includes several features observed in bTBI, such as hemorrhage, edema, pseudoaneurysm formation, vasoconstriction, and induction of apoptosis. These are well-described pathological findings within the SW literature. Acoustic impedance mismatch, penetration of tissue by shock/bubble interaction, geometry of the skull, shear stress, tensile stress, and subsequent cavitation formation, are all important factors in determining the extent of SW-induced tissue and cellular injury. Herein we describe the requirements for the adequate experimental set-up when investigating blast-induced tissue and cellular injury; review SW physics, research, and the importance of engineering validation (visualization/pressure measurement/numerical simulation); and, based upon our findings of SW-induced injury, discuss the potential underlying mechanisms of primary bTBI.

The aim of this study was to clarify the initiation process and the propagation mechanism of positive underwater streamers under the application of pulsed voltage with a duration of 10 μs, focusing on two different theories of electrical discharges in liquids: the bubble theory and the direct ionization theory. The initiation process, which is the time lag from the beginning of voltage application to streamer inception, was found to be related to the bubble theory. In this process, Joule heating resulted in the formation of a bubble cluster at the tip of a needle electrode. Streamer inception was observed from the tip of a protrusion on the surface of this bubble cluster, which acted as a virtual sharp electrode to enhance the local electric field to a level greater than 10 MV/cm. Streak imaging of secondary streamer propagation showed that luminescence preceded gas channel generation, suggesting a mechanism of direct ionization in water. Streak imaging of primary streamer propagation revealed intermittent propagation, synchronized with repetitive pulsed currents. Shadowgraph imaging of streamers synchronized with the light emission signal indicated the possibility of direct ionization in water for primary streamer propagation as well as for secondary streamer propagation.

InAs/AlSb intersubband quantum cascade lasers based on bound-to-continuum transitions are fabricated and operation at 10 μm is demonstrated. A spatially indirect intersubband transition together with a double plasmon waveguide structure is employed. Threshold current density is 4.9 kA/cm2 at 4 K. Temperature dependence of the threshold current density is also presented.

Currently, further clarification of pre-breakdown phenomena in water such as propagation mechanisms of primary and secondary streamers are needed because applications of aqueous plasma to environmental and medical treatments are increasing. In this study, a series of primary streamer propagations in ultrapure water was visualized at 100-Mega frames per second (100 Mfps) in the range of 400 μm square using an ultra high-speed camera with a microscope lens when a single-shot pulsed positive voltage was applied to a needle electrode placed in a quartz cell. Every observation was synchronized with the waveforms of the applied voltage and the discharge current. The primary streamer, having many filamentary channels, started to propagate semi-spherically with a velocity of about 2 km/s when the pulsed currents occurred. Although most filamentary channels disappeared 400 ns after the beginning of the primary streamer, a few of them continued propagating with almost the same velocity (about 2 km/s) as long as the repetitive pulsed currents flowed. Shock waves were iteratively generated and streamer channels were formed while the repetitive pulsed currents were flowing. Thus, we concluded that the positive primary streamer in water propagates progressively with each repetitive pulsed current.

We present experimental observations of microjets formed by cavitation microbubbles. An underwater electric discharge, applied beneath a flat free surface, produces a primary compression wave, which undergoes several phase inversions upon reflections from the free surface and spark-bubble interface. The first reflection yields a tension wave, which produces a cloud of secondary cavitation bubbles in the liquid, some of which form microjets upon collapse. The tuning of these reflections enables an effective control of the microjet direction in the bubble cloud. All of the jets of the microbubbles between the spark bubble and free surface are directed radially away from the spark bubble. The mechanical response of an alumina plate placed between the electrodes and free surface generates a quasi-planar compression wave, which, following its multiple reflections from the free surface and plate, orients the microjets in the same direction toward the plate. These observations imply that the jet direction is determined mainly by the secondary compression wave, which is the first and thus most energetic compression wave acting on a sufficiently grown cavitation bubble.