No abstract

No abstract

Abstract. The mechanical and microstructural properties of 6061 + 20% Al 2 O 3p and 7005 + 10% Al 2 O 3p aluminium based metal matrix composites joined by friction stir welding were analyzed in the present study. The two materials were welded into the form of sheets of 7 mm thickness after T6 treatment and were tested in tension at room temperature. The microstructure of the joints was observed by optical microscopy and the fracture surfaces were analyzed by employing a scanning electron microscope equipped with field emission gun in order to study the micromechanisms involved during the deformation.

No abstract

Two different intergranular corrosion tests were performed on EN AW-6016 sheet material, an ISO 11846:1995-based test with varying solution amounts and acid concentrations, and a standard test of an automotive company (PV1113, VW-Audi). The average intergranular corrosion depth was determined via optical microscopy. The differences in the intergranular corrosion depths were then discussed with regard to the applicability and quality of the two different test methods. The influence of varying test parameters for ISO 11846:1995 was discussed as well. The determined IGC depths were found to be strongly dependent on the testing parameters, which will therefore have a pronounced influence on the determined IGC susceptibility of a material. In general, ISO 11846:1995 tests resulted in a significantly lower corrosion speed, and the corrosive attack was found to be primarily along grain boundaries.