No abstract

This communication reports the design and characterization of an air-breathing laminar flow-based microfluidic fuel cell (LFFC). The performance of previous LFFC designs was cathode-limited due to the poor solubility and slow transport of oxygen in aqueous media. Introduction of an air-breathing gas diffusion electrode as the cathode addresses these mass transfer issues. With this design change, the cathode is exposed to a higher oxygen concentration, and more importantly, the rate of oxygen replenishment in the depletion boundary layer on the cathode is greatly enhanced as a result of the 4 orders of magnitude higher diffusion coefficient of oxygen in air as opposed to that in aqueous media. The power densities of the present air-breathing LFFCs are 5 times higher (26 mW/cm2) than those for LFFCs operated using formic acid solutions as the fuel stream and an oxygen-saturated aqueous stream at the cathode ( approximately 5 mW/cm2). With the performance-limiting issues at the cathode mitigated, these air-breathing LFFCs can now be further developed to fully exploit their advantages of direct control over fuel crossover and the ability to individually tailor the chemical composition of the cathode and anode media to enhance electrode performance and fuel utilization, thus increasing the potential of laminar flow-based fuel cells.

No abstract

No abstract

An increasing societal demand for a wide range of small, often portable devices that can operate for an extended period of time without recharging has resulted in a surge of research in micropower sources. Most efforts in this area focus on downscaling of existing fuel cell technology such as the well-known proton exchange membrane (PEM) fuel cells. Here we study a novel concept for fuel cells: the use of laminar flow instead of a physical barrier such as a PEM to separate the fuel and oxidant streams. Laminar flow, i.e. low Reynolds number flow, is a property of fluid flow at the microscale: one or more liquid streams that are brought together under low Reynolds number conditions flow in parallel and contact with each other without turbulent mixing. Mass transport transverse to the direction of flow takes place by diffusion only. In our laminar flow-based fuel cell a fuel-containing stream and an oxidant-containing stream are brought together in laminar flow conditions with the electrodes placed on opposite walls within the channel. In un-optimized fuel cell configurations, current densities as high as 10 mA/cm2 are obtained at room temperature using different fuels such as methanol or formic acid vs. oxygen saturated solvents or other oxidants.