The EU H2020 MaRINET2 project has a goal to improve the quality, robustness and accuracy of physical modelling and associated testing practices for the offshore renewable energy sector. To support this aim, a round robin scale physical modelling test programme was conducted to deploy a common wave energy converter at four wave basins operated by MaRINET2 partners. Test campaigns were conducted at each facility to a common specification and test matrix, providing the unique opportunity for intercomparison between facilities and working practices. A nonproprietary hinged raft, with a nominal scale of 1:25, was tested under a set of 12 irregular sea states. This allowed for an assessment of power output, hinge angles, mooring loads, and six-degree-of-freedom motions. The key outcome to be concluded from the results is that the facilities performed consistently, with the majority of variation linked to differences in sea state calibration. A variation of 5–10 % in mean power was typical and was consistent with the variability observed in the measured significant wave heights. The tank depth (which varied from 2–5 m) showed remarkably little influence on the results, although it is noted that these tests used an aerial mooring system with the geometry unaffected by the tank depth. Similar good agreement was seen in the heave, surge, pitch and hinge angle responses. In order to maintain and improve the consistency across laboratories, we make recommendations on characterising and calibrating the tank environment and stress the importance of the device–facility physical interface (the aerial mooring in this case).

The extraction of power from the flow of water has become an important potential source of clean energy. In spite of significant interest in the interaction between energy extraction devices and water currents, comparatively little work has focused on flow asymmetry. Indeed, unusual wake behaviour and limits of turbine array efficiency have typically been attributed to boundary effects rather than the particular turbine geometry. The aim of the present study was to reveal the asymmetries in the hydrodynamic wake and the interactions with the sediment bed due to the presence of a hydrokinetic turbine. We combined:(i) computational fluid dynamics simulations; (ii) optical flow measurements from a series of flume experiments above a fixed rough bed; and (iii) acoustic measurements from a further series of flume experiments above a mobile sand bed. Results showed flow asymmetry due to the presence of the rotor which appeared to be related to the development of the wake and potentially to the gyre of the blades. Suspended sediments in the flume also exhibited asymmetrical characteristics due to the flow asymmetry. This imbalance in the flow field and sediment transport may decrease energy extraction efficiency in turbine arrays and also could have important environmental consequences.

No abstract

No abstract

No abstract