The region 1273-1290 cm

Time-of-flight secondary-ion mass spectrometry (ToF-SIMS) has been used for gaining insights into perovskite solar cells (PSCs). However, the importance of selecting ion beam parameters to eliminate artifacts in the resulting depth profile is often overlooked. In this work, significant artifacts were identified with commonly applied sputter sources, i.e., an O 2 + beam and an Ar-gas cluster ion beam (Ar-GCIB), which could lead to misinterpretation of the PSC structure. On the other hand, polyatomic C 60 + and Ar + ion beams were found to be able to produce depth profiles that properly reflect the distribution of the components. On the basis of this validated method, differences in component distribution, depending on the fabrication processes, were identified and discussed. The solvent-engineering process yielded a homogeneous film with higher device performance, but sequential deposition led to a perovskite layer sandwiched by methylammonium-deficient layers that impeded the performance. For device degradation, it was found that most components remained intact at their original position except for iodide. This result unambiguously indicated that iodide diffusion was one of the key factors governing the device lifetime. With the validated parameters provided, ToF-SIMS was demonstrated as a powerful tool to unveil the structure variation amid device performance and during degradation, which are crucial for the future development of PSCs.

Lithium-sulfur all-solid-state batteries using inorganic solid-state electrolytes are considered promising electrochemical energy storage technologies. However, developing positive electrodes with high sulfur content, adequate sulfur utilization, and high mass loading is challenging. Here, to address these concerns, we propose using a liquid-phase-synthesized Li3PS4-2LiBH4 glass-ceramic solid electrolyte with a low density (1.491 g cm−3), small primary particle size (~500 nm) and bulk ionic conductivity of 6.0 mS cm−1 at 25 °C for fabricating lithium-sulfur all-solid-state batteries. When tested in a Swagelok cell configuration with a Li-In negative electrode and a 60 wt% S positive electrode applying an average stack pressure of ~55 MPa, the all-solid-state battery delivered a high discharge capacity of about 1144.6 mAh g−1 at 167.5 mA g−1 and 60 °C. We further demonstrate that the use of the low-density solid electrolyte increases the electrolyte volume ratio in the cathode, reduces inactive bulky sulfur, and improves the content uniformity of the sulfur-based positive electrode, thus providing sufficient ion conduction pathways for battery performance improvement.

No abstract

No abstract