No abstract

TiO2 exposed high energy crystal plane (001) was prepared by the sol-gel process using butyl titanate as the titanium source and hydrofluoric acid as the surface control agent. Ag-TiO2 was prepared by depositing Ag on the crystal plane of TiO2 (101) with a metal halide lamp. The surface morphology, interplanar spacing, crystal phase composition, ultraviolet absorption band, element composition, and valence state of the samples were characterized by using field emission scanning electron microscopy (FESEM), transmission electron microscope (TEM), X-ray diffraction (XRD), ultraviolet-visible absorption spectrum (UV-Vis-Abs), and X-ray photoelectron spectroscopy (XPS), respectively. The formation mechanism of high energy crystal plane (001) was discussed, and the photocatalytic activities were evaluated by following degradation of methyl orange. The results show that TiO2 exposed the (001) crystal plane with a ratio of 41.8%, and Ag can be uniformly deposited on the crystal plane of TiO2 (101) by means of metal halide lamp deposition. Under the same conditions, the degradation rate of methyl orange by deposited Ag-TiO2 reaches as much as 93.63% after 60 min using the metal halide lamp (300 W) as an illuminant, 81.89% by non-deposited samples and 75.20% by nano-TiO2, causing a certain blue shift in the light absorption band edge of TiO2. Ag-TiO2 has the best photocatalytic performance at a pH value of 2.

No abstract

The precursor for a lithium-ion sieve is prepared using an inorganic precipitation-peptization method with titanium sulfate as the titanium source and lithium acetate as the lithium source. The effects of Ni2+ (Nickel ions) doping on the stability of the sol, crystal morphology and interplanar spacing of Li2TiO3 are investigated. The results indicate that, after Ni2+ doping with varying fractions, the stability of the precursor sol first increases then decreases, and the maximum stabilization time of the precursor sol doped with 1% Ni2+ is 87 h. When doped with 1% Ni2+, the sol performance is most stable, the porous Li2TiO3 is obtained, and the specific surface area of Li2TiO3 increases by up to 1.349 m2/g from 0.911 m2/g. Accompanying the increase in calcination temperature, the inhibition of Ni2+ doping on the growth and crystallization of grains decreases. When the temperature is lower than 750 °C, Ni atoms replace the Ti atoms that are substituted for Li atoms in the original pure Li layer, forming lattice defects, resulting in the disappearance of (002) and (−131) diffraction peaks for Li2TiO3, the reduced ordering of crystal structure, a decrease in the interplanar spacing of the (002) plane, lattice expansion and an increase in the particle size to 100–200 nm. When the temperature exceeds 750 °C, with the increase of calcination temperature, the influence of Ni doping on the growth and crystallinity of grains decreases, and the (002) crystal surface starts to grow again.

Nickel aluminum layered double hydroxides were coupled with layered mesoporous titanium dioxide to obtain Ni–Al LDHs/LM-TiO2 composites with dual adsorption and photodegradation properties by the hydrothermal approach.