In aircraft engineering, an increase of internal pressure in a hydraulic pipe increases the probability of pipe damage, leading to crack propagation becoming a serious issue. In this study, the extended finite element method (XFEM) is applied to simulate initial crack propagation in hydraulic pipes and to investigate the influence factors. Stress intensity factors are extracted to verify the mesh independence of XFEM, which is based on the level set method and unit decomposition method. A total of 30 finite element models of hydraulic pipes with cracks are established. The distribution of von Mises stress under different initial crack lengths and internal pressures is obtained to analyze the change of load-carrying capacity in different conditions. Then, a total of 300 finite element models of hydraulic pipes with different initial crack sizes and locations are simulated under different working conditions. The relationship between the maximum opening displacement and crack length is analyzed by extracting the opening displacement under different initial crack lengths. The length and depth of the initial crack are changed to analyze the factors affecting crack propagation. The opening size and crack propagation length are obtained in different directions. The results show that radial propagation is more destructive than longitudinal propagation for hydraulic pipes in the initial stage of crack propagation.

By applying finite element software ANSYS/LS-DYNA, finite element models of front bulkhead and main cabin are established, which aims to assess the dynamic response of fuselage structures impacted by tire fragment under bursting mode. Besides, dynamic characteristics of the two fuselage structures impacted by tire fragment are simulated and critical damage velocities of each working condition are obtained. The results show that composite front bulkhead cannot bear the impact load of front tire fragment at the velocity of 100 m/s, but aluminum alloy front bulkhead can. Main cabin with two properties both can bear the impact loads of front and main tire fragments. When impacted by front tire fragment, critical damage velocity of front bulkhead is approximately half of that of main cabin, while critical damage velocity of aluminum alloy fuselage is larger than that of composite fuselage. However, when impacted by main tire fragment, critical damage velocity of aluminum alloy main cabin is less than that of composite main cabin. Furthermore, maximum contact pressure of composite fuselage is 3–3.3 times than that of aluminum alloy fuselage. The difference in concave deformation is not significant when impacted by front tire fragment, but the difference is great when impacted by main tire fragment.