A simple, rapid, and efficient method, dispersive liquid-liquid microextraction (DLLME), has been developed for the extraction and preconcentration of decabrominated diphenyl ether (BDE-209) in environmental water samples. The factors relevant to the microextraction efficiency, such as the kind and volume of extraction and dispersive solvent, the extraction time, and the salt effect, were optimized. Under the optimum conditions (extraction solvent: tetrachloroethane, volume, 22.0 microL; dispersive solvent: THF, volume, 1.00 mL; extraction time: below 5 s and without salt addition), the most time-consuming step is the centrifugation of the sample solution in the extraction procedure, which is about 2 min. In this method, the enrichment factor could be as high as 153 in 5.00 mL water sample, and the linear range, correlation coefficient (r(2)), detection limit (S/N = 3), and precision (RSD, n = 6) were 0.001-0.5 microg/mL, 0.9999, 0.2 ng/mL, and 2.1%, respectively. This method was successfully applied to the extraction of BDE-209 from tap, East Lake, and Yangtse River water samples; the relative recoveries were 95.8, 92.9, and 89.9% and the RSD% (n = 3) were 1.9, 2.7, and 3.5%, respectively. Comparison of this method with other methods, such as solid-phase microextraction (SPME), and single-drop microextraction (SDME), indicates that DLLME is a simple, fast, and low-cost method for the determination of BDE-209, and thus has tremendous potential in polybrominated diphenyl ethers (PBDEs) residual analysis in environmental water samples.
