No abstract

The frequency noise properties of commercial distributed feedback quantum cascade lasers emitting in the 4.6 μm range and operated in cw mode near room temperature (277 K) are presented. The measured frequency noise power spectral density reveals a flicker noise dropping down to the very low level of <100 Hz(2)/Hz at 10 MHz Fourier frequency and is globally a factor of 100 lower than data recently reported for a similar laser operated at cryogenic temperature. This makes our laser a good candidate for the realization of a mid-IR ultranarrow linewidth reference.

Abstract:We report on the measurement of the frequency noise power spectral density in a distributed feedback quantum cascade laser over a wide temperature range, from 128 K to 303 K. As a function of the device temperature, we show that the frequency noise behavior is characterized by two different regimes separated by a steep transition at ≈200 K. While the frequency noise is nearly unchanged above 200 K, it drastically increases at lower temperature with an exponential dependence. We also show that this increase is entirely induced by current noise intrinsic to the device. In contrast to earlier publications, a single laser is used here in a wide temperature range allowing the direct assessment of the temperature dependence of the frequency noise. Baillargeon, and A. Y. Cho, "Rapid-scan Doppler-limited absorption spectroscopy using mid-infrared quantum cascade lasers," Proc. SPIE 3758, 23-33 (1999). 4. T. L.

No abstract

We describe a radio-frequency (RF) discriminator, or frequency-to-voltage converter, based on a voltage-controlled oscillator phase-locked to the signal under test, which has been developed to analyze the frequency noise properties of an RF signal, e.g., a heterodyne optical beat signal between two lasers or between a laser and an optical frequency comb. We present a detailed characterization of the properties of this discriminator and we compare it to three other commercially available discriminators. Owing to its large linear frequency range of 7 MHz, its bandwidth of 200 kHz and its noise floor below 0.01 Hz 2 /Hz in a significant part of the spectrum, our frequency discriminator is able to fully characterize the frequency noise of a beat signal with a linewidth ranging from a couple of megahertz down to a few hertz. As an example of application, we present measurements of the frequency noise of the carrier envelope offset beat in a low-noise optical frequency comb.