Background An effective regenerative protocol is key to reestablish and maintain the hard and soft tissue dimensions over time. The choice of the graft material and its properties also could have an impact on the results. To prevent alveolar ridge dimensional changes, since numerous graft materials have been suggested and in the past years, a growing interest in teeth material has been observed as a valuable alternative to synthetic biomaterials. Aim The aim of the study was to explore the histomorphometric outcomes of tooth derivative materials as used as bone substitute material in socket preservation procedure. Methods After alveolar socket preservation (ASP) procedures using autologous demineralized tooth as graft material prepared by means of an innovative device, was evaluated. A total of 101 histological samples, from 96 subjects, were analyzed by evaluating the total amount of bone (BV), residual tooth material (residual graft, TT), and vital bone (VB). The section from each sample was then split in nine subsections, resulting in 909 subsections, to allow statistical comparison between the different areas. Results It was not noticed a statistically significant difference between maxillary and mandibular sites, being the amount of VB in upper jaw sites 37.9 ± 21.9% and 38.0 ± 22.0% in lower jaw sites and the amount of TT was 7.7 ± 12.2% in maxilla and 7.0 ± 11.1% in mandibles. None of the other considered parameters, including defect type and section position, were statistically correlated to the results of the histomorphometric analysis. Conclusions ASP procedure using demineralized autologous tooth‐derived biomaterial may be a predictable procedure to produce new vital bone potentially capable to support dental implant rehabilitation.

(1) Background: Different techniques and tools have been developed for implant site preparation. In this clinical scenario, Hybrid Funnel Technique (HFT), a novel osteotomy procedure, has been proposed. (2) Aim: The aim of this retrospective observational study was to consider the different responses to compression of the histological bony compartments (cancellus and cortical). HFT involves the use of multiple drills for the cortical layer preparation and of an osteotome for the osteocompaction of the cancellous bone. (3) Materials and Methods: Following computer-supported implant planning and guided surgery, 10 osteotomies with HFT were performed and 10 implants with the same length and diameter were placed in seven healthy and no daily smoking patients. Periapical X-ray and intraoral photographs were performed at baseline and after 12 months of follow-up to evaluate marginal bone level (MBL) changes and aesthetic results obtained from implant prosthetic rehabilitation. (4) Results: At 1 year of follow-up, 100% of the implants were successfully integrated, MBL change mean value was 0.17 mm ± 0.21. No differences in terms of MBL were noted between thin and thick biotypes. Pink esthetic score (PES) and white esthetic score (WES), assessed one year after definitive restoration placement, were 7.5 ± 2.3 and 8.5 ± 1.1, respectively. (5) Conclusions: Based on the findings of this preliminary clinical study, HFT has led to stability of peri-implant tissues and could represent a reliable technique for surgical preparation of the implant site.

No abstract

(1) Background: The aim of this study is to understand from a microscopic point of view whether bicarbonate air-abrasive powders associated with ultrasonic instruments can decontaminate nine different surfaces used for the abutment/implant junction. Fibroblast growth was carried out on decontaminated surface in order to understand if there are significative differences in terms of biocompatibility. (2) Methods: After taking samples of patient plaque, nine different surfaces were contaminated and analyzed by SEM, then their wettability was evaluated. Fibroblasts were cultured on the decontaminated surfaces to understand their ability to establish a connective tissue seal after decontamination. The results were analyzed from a statistical point of view to hypothesize a mathematical model capable of explaining the properties of the surfaces. (3) Results: A negative correlation between roughness and contamination has been demonstrated, whereas a weak correlation was observed between wettability and decontamination capacity. All surfaces were topographically damaged after the decontamination treatment. Grade 5 titanium surfaces appear tougher, whereas anodized surfaces tend to lose the anodizing layer. (4) Conclusions: further studies will be needed to fully understand how these decontaminated surfaces affect the adhesion, proliferation and differentiation of fibroblasts and osteoblasts.

Background: Bone grafting in post-extractive site improves tissue regeneration. Soft tissue sealing of the grafted post-extractive alveolus is supposed to limit microbiological contamination from the oral cavity and to stabilize the coagulum. Several techniques are presented in the literature to reach this goal using different heterologous matrices or autogenous grafts. In addition, recently, a technique based on the use of granulation tissue in the post-extractive alveolus has been proposed. Aim: To compare the effect of different graft sealing approaches in post-extractive sites by qualitatively evaluating their healing process. Materials and Methods: This retrospective investigation included 30 patients requiring post-extractive site regeneration in the aesthetic area. Post-extractive sites were regenerated using a bovine bone matrix and patients were divided into three groups (10 patients in each group) according to the material used to seal the alveolar socket. In the UD group, the granulation tissue was used to seal the defect; in the PC group, epithelial-connective soft tissue graft was used, and in the COLL group, a collagen-based membrane was employed. Images of the post-extractive sites at different follow-up periods (2 and 12 weeks) were taken and the healing process was blindly evaluated by two independent practitioners. The Healing Index (HI) by Landry, Turnbull and Howley was used to assess the quality of the healing process. The combination of presence/absence of five clinical criteria defines an HI ranging from 1 (very poor) to 5 (excellent). Patients’ clinical-pathological variables were recorded. One-way ANOVA was used to explore the dependence of HI on the different socket preservation protocols. Results: Based on clinical-pathological characteristics of the included patients, there were no statistically significant differences among the different sealing techniques. At the 2-week follow-up appointment, HI did not differ among the socket preservation protocols evaluated. Moreover, smoking status and reason for extraction did not influence the HI among the three groups (two-way ANOVA p-value = 0.686, p-value = 0.248 respectively). At the 2-week follow-up appointment, HI was significantly different among the socket preservation protocols investigated. Specifically, the group undergoing collagen-based socket preservation procedure reported the highest HI, compared to the other two techniques (COLL mean 4.60 ± 0.5; PC mean 3.5 ± 1.2; UD mean 3.4 ± 0.5, one-way ANOVA p-value 0.006). Conclusions: The use of collagen porcine membranes may represent a suitable option to improve the patient healing process in grafted post-extractive sites together with reducing the surgical intervention time compared to alternative sealing techniques.