No abstract

Polymethyl methacrylate (PMMA) plates are widely used in buildings or factories for natural lighting. Commonly PMMA plates are installed as a discrete array. However, PMMA plates are very susceptible to fire. Therefore, experimental study on flammability and fire hazard of vertical PMMA plate array with different overlap length (D) was conducted in this work. The average flame height (Hf) increases first and then decreases with an increase in the overlap length, and reaches the maximum when D = 40 mm. The discrete flame spread speed (Vf) also rises first and then drops with the increase of D, which is mainly due to the heat transfer from the PMMA flame to the next plate. A model for predicting the flame spread rate of discrete PMMA array is established. The predicted results are consistent with experimental ones, with a predicted error smaller than 15%. The average temperature of flame zone rises first and then drops as D increases, reaching the maximum when D = 40 mm. This leads to the same changing trend of radiative heat flux. Results obtained in this work provide a reference for fire hazard evaluation and fire safety design of PMMA plates employed in buildings or industrial sites.

SUMMARY Fire hazard of extruded polystyrene (XPS) thermal insulation materials has aroused public concern. In order to develop flame spread theory and the guideline for fire risk assessment of XPS, an experimental study on upward flame spread behavior and heat transfer mechanism of XPS in a vertical channel with different frontal shielding rates was conducted. Maximum temperature at the place 2 cm from XPS surface and at the center of channel first increase and then decrease as the shielding rate rises. The former is higher than the latter. Experimental value of average flame height rises as the shielding rate increases. A model for predicting the flame height is built, and the predicted results are consistent with the experimental results. Moreover, the relation between flame height and pyrolysis height under different shielding rates is obtained. The flame spread rate rises as the shielding rate increases. A prediction model of flame spread rate is established, and its prediction results are more accurate compared with those from previous models. The model also predicts that radiative heat transfer is the dominant heat transfer mode, accounting for 93% of the total heat transfer. This work is beneficial for fire risk assessment and fire safety design of building façade.

No abstract

Polymethyl methacrylate plates are widely applied to buildings, producing significant fire hazards. It lacks a theoretical basis for the fire risk assessment of polymethyl methacrylate in concave building facades. Therefore, experimental methods are used to investigate combustion characteristics of discrete polymethyl methacrylate plates in a concave building facade. Influences of fuel coverage and structure factor are investigated, which is scant in previous works. When structure factor is invariable, average flame height increases first and then decreases as fuel coverage increases, and the turning point is between 0.64 and 0.76. In total, three different patterns of pyrolysis front propagation are first observed for different fuel coverages. Flame spread rate first increases and then decreases as fuel coverage rises, and the turning point is also between 0.64 and 0.76. When fuel coverage is invariable, the flame spread rate first increases and then decreases with increasing structure factor, and the turning point is 1.2. A model for predicting the flame spread rate of discrete polymethyl methacrylate is also developed. The predicted values are consistent with experimental results. Fuel spread rate of discrete polymethyl methacrylate rises as the fuel coverage increases. The above results are beneficial for thermal hazard evaluation and fire safety design of polymethyl methacrylate used in buildings.