Cathode electrodes of proton exchange membrane fuel cells were fabricated by using Pt sputter deposition to increase the gravimetric power density (W mg Pt -1 ) with reduced Pt loading. Ultra low Pt-based electrodes having Pt loading in between 0.0011 and 0.06 mg Pt cm -2 were prepared by a radio frequency (RF) sputter deposition method on the surface of a non-catalyzed gas diffusion layer (GDL) substrate by changing the sputtering time (20, 90, 180, 1050 s). The effect of cathode Pt loading on the performance of membrane electrode assembly were investigated using polarization curve, impedance, H 2 crossover and cyclic voltammetry techniques. ) showed the peak gravimetric power density (15 W mg Pt -1 and 75 mW cm -2 at 0.6 V). The Pt utilization efficiency increased as the Pt loading decreased. Sputter20 and sputter90 electrodes yielded insufficient electrochemical surface area (ECSA), higher charge transfer and ohmic resistance, but sputter180 and sputter1050 yielded sufficient ECSA and lower charge transfer and ohmic resistance.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.