Ti-Si-C-ON films were deposited by DC reactive magnetron sputtering using different partial pressure ratio of oxygen (p O 2 ) and nitrogen (p N 2 ). Compositional analysis revealed the existence of three different growth zones for the films; (I) N/Ti = 2.1 (high atomic ratio) and low oxygen content; (II) 0.76 b N/Ti b 2.1 (intermediate atomic ratio) and (III) N/Ti ≤ 0.12 (low ratio) and high oxygen content. For high N/Ti atomic ratio (N/Ti = 2.1) the XRD pattern exhibits reflections that correspond to a mixture of two different phases: a metallic-like Ti and a fcc NaCl type structure. Its electrical resistivity presents a metallic character and, consequently, has high infrared reflectivity. For the intermediate N/Ti ratio (0.76 b N/Ti b 2.1), the films crystallize in a B1-NaCl crystal structure typical for TiC 0.2 N 0.8 . Their FTIR spectra present C-N modes, besides the TiN ones, that indicate a progressive substitution of nitrogen by carbon atoms with increasing oxygen content (and lowering N/Ti ratio). For the highest oxygen content (and lower N/Ti ratio) the presence of the Ti-O-Ti stretching mode shows the formation of highly resistive Ti-O compounds consistent with the semiconductor character of this film. Biofilm formation as well as material cytotoxicity seemed to be related with the presence of the Ti.

The fabrication of segmented Ni/Cu nanowires (NWs), with tunable structural and magnetic properties, is reported. A potentiostatic electrodeposition method with a single electrolytic bath has been used to fabricate multisegmented Ni/Cu NWs inside a highly hexagonally ordered anodic nanoporous alumina membrane, with diameters of 50 nm and Ni segment lengths (L Ni) tuned from 10 nm up to 140 nm. The x-ray diffraction results evidenced a strong dependence of the Ni NWs crystallographic face-centered-cubic (fcc) texture along the [220] direction on the aspect ratio of the NWs. The magnetic behavior of the multisegmented Ni/Cu NW arrays, as a function of the magnetic field and temperature, is also studied and correlated with their structural and morphological properties. Micromagnetic simulations, together with the experimental results, showed a dominant antiferromagnetic coupling between Ni segments along the wire length for small low aspect-ratio magnetic segments. When increasing the Ni segments' length, the magnetic interactions between these along the wire became stronger, favouring a ferromagnetic coupling. The Curie temperature of the NWs was also found to strongly depend on the Ni magnetic segment length. Particularly the Curie temperature was found to be reduced 75 K for the 20 nm Ni segments, following the finite-size scaling relation with ξ 0 = 8.1 Å and γ = 0.48. These results emphasize the advantages of using a template assisted method to electrodeposit multilayer NWs, as it allows an easy tailor of the respective morphological, chemical, structural and magnetic properties.

Aims:  Poultry meat is considered a major source of Campylobacter. This micro‐aerobic bacterium is commonly responsible for foodborne illness. This work focuses on the isolation of Campylobacter coli lytic bacteriophages (phages) against target C. coli strains. Methods and Results:  A method involving the enrichment of free‐range chicken samples in a broth containing the target C. coli strains and salts (CaCl2 and MgSO4) was used for phage isolation. This method allowed the isolation of 43 phages that were active against 83% of the C. coli strains used in the isolation procedure. Approximately 65% of the phages were also effective against Campylobacter jejuni strains. Conclusions:  The use of target pathogens in the phage isolation step improves the likelihood of detecting and isolating phages for the control of these specific strains. Significance and Impact of the Study:  This technique will be valuable in the context of phage therapy for enriching for phages that are active against specifically identified strains of bacteria, for example from a food poisoning outbreak or epidemic strains resistant to multiple antibiotics. In these situations, using the conventional methods for searching for bacteriophages active for these particular strains can be a time‐consuming, if not an unsuccessful process. Using the isolation method described in this manuscript, the particular strains can be added to the enrichment broth increasing the probability of finding phages against them. Therefore, it will shorten the time needed for seeking phages able to lyse target strains, which in most of the cases, because of the rapid increase in antimicrobial‐resistant bacteria, is of crucial importance.