Abstract:We report the fabrication and characterization of the first guiding chalcogenide As 2 S 3 microstructured optical fibers (MOFs) with a suspended core. At 1.55 µm, the measured losses are approximately 0.7 dB/m or 0.35 dB/m according to the MOF core size. The fibers have been designed to present a zero dispersion wavelength (ZDW) around 2 µm. By pumping the fibers at 1.55 µm, strong spectral broadenings are obtained in both 1.8 and 45-m-long fibers by using a picosecond fiber laser. C. Miller, "Role of S/Se ratio in chemical bonding of As-S-Se glasses investigated by Raman, X-ray photoelectron, and extended X-ray absorption fine structure spectroscopies," J. ©2010 Optical Society of America

Abstract:We present a new method for measuring the group dispersion of the fundamental mode of a holey fiber over a wide wavelength range by white-light interferometry employing a low-resolution spectrometer. The method utilizes an unbalanced Mach-Zehnder interferometer with a fiber under test placed in one arm and the other arm with adjustable path length. A series of spectral signals are recorded to measure the equalization wavelength as a function of the path length, or equivalently the group dispersion. We reveal that some of the spectral signals are due to the fundamental mode supported by the fiber and some are due to light guided by the outer cladding of the fiber. Knowing the group dispersion of the cladding made of pure silica, we measure the wavelength dependence of the group effective index of the fundamental mode of the holey fiber. Furthermore, using a full-vector finite element method, we model the group dispersion and demonstrate good agreement between experiment and theory.

We calculated the sensitivity of phase (dB/dp) and group (dG/dp) modal birefringence to hydrostatic pressure versus wavelength in two birefringent holey fibers of different construction, where B is the phase modal birefringence, G is the group modal birefringence, and p is the pressure applied to the fiber. The contributions of the geometrical effects that were related only to deformation of the holey structure and the stress-related contribution to the overall pressure sensitivities were analyzed separately. Our results show that these two factors decrease the phase modal birefringence in both structures, which results in negative signs of dB/dp and dG/dp. Furthermore, we demonstrate that the geometrical effects are much weaker than the stress-related effects and contribute only a few percent to the overall pressure sensitivity.

We have manufactured and characterized a birefringent holey fiber of a new construction. The birefringence in this fiber is induced by the highly elliptical shape of the core, which consists of a triple defect in a hexagonal structure. Using a hybrid edge-nodal finite-element method, we calculated the spectral dependence of phase and group modal birefringence for spatial modes E11 and E21 in idealized and in real fiber, whose geometry we determined by using a scanning-electron microscope. Results of our calculations show that technological imperfections significantly affect the fiber's birefringence. Normalized cutoff wavelengths for higher-order modes relative to the filling factor were also determined for the idealized structure. We observed a significant disagreement between theoretical and experimental values of cutoff wavelengths, which was attributed to high confinement losses near the cutoff condition. We also measured the spectral dependence of the phase and the group modal birefringence for spatial modes E11 and E21. The measured parameters showed good agreement with the results of modeling.