The objectives of this study were to determine how periphyton and phytoplankton biomass vary with grazing pressure by tilapia Oreochromis niloticus, to evaluate the growth performance of fish when substrate is introduced and to calculate the efficiency of nitrogen utilization in substrate and non‐substrate systems. Ten circular 1000‐L plastic tanks were filled with 15 cm of loamy soil bottom and water. Five different treatments were applied: eight tilapias with substrate (treatment 8T/S), eight tilapias without substrate (treatment 8T), four tilapias with substrate (treatment 4T/S), four tilapias without substrate (treatment 4T) and no tilapia with substrate (treatment 0T/S). Each week, 2 g of NaNO3 and 3.5 g of single superphosphate (SSP) were applied to each tank. Sixteen glass slides (1 m×4 cm×4 mm) were installed vertically in the tank bottom, one portion extending above the water surface and equally spaced within the water column in all substrate tanks. Periphyton and phytoplankton quantity and quality, water quality, fish growth and proximate fish composition were measured. Because of grazing, phytoplankton and periphyton biomass decreased after the introduction of fish to the tanks. The periphyton biomass was higher in non‐fish tanks (treatment 0T/S) throughout the experiment than that in tanks with fish (treatments 8T/S and 4T/S). The periphyton biomass was similar in the 4T/S and 8T/S treatments, suggesting that the grazing pressure on periphyton biomass reached threshold levels. Fish ate 25–36% of the total standing biomass every day. Tilapia growth was significantly higher in treatments with substrate. Nitrogen retention was double in substrate ponds compared with in control ponds. There were no significant effects of periphyton substrate or fish density on body composition of fish.

No abstract

No abstract

Abstract-A microstrip bandpass filter with a new type of capacitive coupled resonator is presented. The filter is designed to be smaller compared to the same type of parallel-coupled bandpass filter. The filter is designed for a centre frequency of 2.5 GHz that lies in the S-band frequency range. The insertion loss at f o is 2.4 dB and the measured 3 dB bandwidth is 8.6%. The agreement between the predicted and measured results is excellent, and even the circuit simulator gives a very good prediction for the filter characteristics.

We show numerically that the reflectivity of multilayer extreme-UV (EUV) mirrors tuned for the 11-14-nm spectral region, for which the two-component, Mo/Be and Mo/Si multilayer systems with constant layer thickness are commonly used, can be enhanced significantly when we incorporate additional materials within the stack. The reflectivity performance of the quarter-wavelength multilayers can be enhanced further by global optimization procedures with which the layer thicknesses are varied for optimum performance. By incorporating additional materials of differing complex refractive indices-e.g., Rh, Ru, Sr, Pd, and RbCl-in various regions of the stack, we observed peak reflectivity enhancements of as much as ~5% for a single reflector compared with standard unoptimized stacks. We show that, in an EUV optical system with nine near-normal-incidence mirror surfaces, the optical throughput may be increased by a factor as great as 2. We also show that protective capping layers, in addition to protecting the mirrors from environmental attack, may serve to improve the reflectivity characteristics.