No abstract

No abstract

No abstract

UNS S32205 duplex stainless steel welds were performed by friction stir welding (FSW). Advancing and retreating sides showed distinct characteristics in the welded joint. The advancing side shows the strongest grain refinement which is corroborated by microhardness measurements. The microstructure characterization was carried out by optical, scanning and transmission electron microscopy. The thermomechanically affected zone displays austenite islands deformed in a ferrite matrix. The stir zone (SZ) showed a fine recrystallized microstructure providing an outstanding increase of hardness associated with better corrosion performance. Transmission electron microscopy and corrosion tests have corroborated the absence of intermetallic phases on welded joints.

This paper describes the microstructural evolution of friction taper plug welded joints of C-Mn steels. Experimental and numerical analyses included calculations based on Calphad and continuous cooling transformation curves, and characterisation techniques. The studied friction taper plug welded joint contains three macroregions: plug material, thermomechanically affected zone (TMAZ) and base material. The thermomechanical conditions imposed in the studied friction taper plug welded joint precluded the formation of a heat affected zone. However, seven subregions were identified within the TMAZ region and details are discussed. The interface zone is found in the TMAZ region, where the most relevant phase transformations take place. It is suggested that the phase transformations in TMAZ region depend on local conditions, such as chemical composition, deformation rate, thermal history and the previous thermomechanical history of the parent materials.