We report a general synthetic approach to tetrapod-shaped colloidal nanocrystals made of various combinations of II-VI semiconductors. Uniform tetrapods were prepared using preformed seeds in the sphalerite structure, onto which arms were grown by coinjection of the seeds and chemical precursors into a hot mixture of surfactants. By this approach, a wide variety of core materials could be chosen (in practice, most of the II-VI semiconductors that could be prepared in the sphalerite phase, namely, CdSe, ZnTe, CdTe); in contrast, the best materials for arm growth were CdS and CdTe. The samples were extensively characterized with the aid of several techniques.

We report the synthesis, the structural and optical characterization of CdSe/CdS/ZnS "double shell" nanorods and their exploitation in cell labeling experiments. To synthesize such nanorods, first "dot-in-a-rod" CdSe(dot)/CdS(rod) core/shell nanocrystals were prepared. Then a ZnS shell was grown epitaxially over these CdSe/CdS nanorods, which led to a fluorescence quantum yield of the final core-shell-shell nanorods that could be as high as 75%. The quantum efficiency was correlated with the aspect ratio of the nanorods and with the thickness of the ZnS shell around the starting CdSe/CdS rods, which varied from 1 to 4 monolayers (as supported by a combination of X-ray diffraction, elemental analysis with inductively coupled plasma atomic emission spectroscopy and high resolution transmission electron microscopy analysis). Pump-probe and time-resolved photoluminescence measurements confirmed the reduction of trapping at CdS surface due to the presence of the ZnS shell, which resulted in more efficient photoluminescence. These double shell nanorods have potential applications as fluorescent biological labels, as we found that they are brighter in cell imaging as compared to the starting CdSe/CdS nanorods and to the CdSe/ZnS quantum dots, therefore a lower amount of material is required to label the cells. Concerning their cytotoxicity, according to the MTT assay, the double shell nanorods were less toxic than the starting core/shell nanorods and than the CdSe/ZnS quantum dots, although the latter still exhibited a lower intracellular toxicity than both nanorod samples.

We investigated the transient bleaching and absorption of the asymmetric core/shell CdSe/CdS nanorods using the pump-probe technique. We observed ultrafast carrier relaxation and identified hole localization dynamics with 650 +/- 80 fs time constant. Upon pumping the CdSe core, we found an intense bleaching signal in the CdS spectral region, which we assigned to the delocalization of the electronic wave function on the basis of envelope-function theoretical calculations.

Colloidal semiconductor quantum rods have demonstrated many advantageous properties as light emitters such as high quantum yield, tunable emission wavelength, and polarized emission. This makes them an interesting optical gain material for laser applications. We report room-temperature gain lifetimes in core/shell CdSe/CdS quantum rods exceeding 300 ps, and show that the long gain lifetimes result from the significant reduction of Auger recombination in our quantum rods, even though the electrons are delocalized over the rod volume. We also fabricate devices by deposition of small droplets of quantum rod solution onto flat substrates. The evaporation dynamics of the droplets are governed by the coffee stain effect which leads to the formation of well defined micron-size stripes. These stripes consist of densely packed, laterally aligned quantum rods and provide optical feedback originating from the abrupt changes of refractive index at the stripe borders. We exploit the optical gain and the coffee stain mediated self-assembly and show that we can fabricate novel microlasers solely by deposition of droplets of quantum rod solutions on flat substrates.