Fiber Bragg gratings (FBGs) are valuable dosimeters for doses up to 100 kilograys (kGy), but have hardly been used for the low-dose range of a few grays (Gy) required in medical radiation dosimetry. We report that embedding a doped silica fiber FBG in a polymer material allows a minimum detectable dose of 0.3 Gy for γ-radiation. Comparing the detector response for different doped silica fibers with various core doping, we obtain an independent response, in opposition to what is reported for high-dose range. We hypothesized that the sensor detection is based on the radio-induced thermal expansion of the surrounding polymer. Hence, we used a simple physical model based on the thermal and mechanical properties of the surrounding polymer and obtained good accordance between measured and calculated values for different compositions and thicknesses. We report that over the 4 embedding polymers tested, polyether ether ketone and polypropylene have respectively the lowest (0.056 pm/Gy) and largest sensitivity (0.087 pm/Gy). Such FBG-based dosimeters have the potential to be distributed along the fiber to allow multipoint detection while having a sub-millimeter size that could prove very useful for low-dose applications, in particular for radiotherapy dosimetry.

International audienceGranule cells (GCs) in the olfactory bulb (OB) play an important role in odor information processing. Although they have been classified into various neurochemical subtypes, the functional roles of these subtypes remain unknown. We used in vivo two-photon Ca2+ imaging combined with cell-type-specific identification of GCs in the mouse OB to examine whether functionally distinct GC subtypes exist in the bulbar network. We showed that half of GCs express Ca2+/calmodulin-dependent protein kinase IIα (CaMKIIα+) and that these neurons are preferentially activated by olfactory stimulation. The higher activity of CaMKIIα+ neurons is due to the weaker inhibitory input that they receive compared to their CaMKIIα-immunonegative (CaMKIIα−) counterparts. In line with these functional data, immunohistochemical analyses showed that 75%–90% of GCs expressing the immediate early gene cFos are CaMKIIα+ in naive animals and in mice that have been exposed to a novel odor and go/no-go operant conditioning, or that have been subjected to long-term associative memory and spontaneous habituation/dishabituation odor discrimination tasks. On the other hand, a perceptual learning task resulted in increased activation of CaMKIIα− cells

Fiber Bragg gratings (FBGs) have proven to be a valuable dosimeter in nuclear environment where radiation doses reach up to a hundred of kiloGray (kGy). Multiple FBGs can be written in a single fiber to allow multi-point detection which would prove very useful for radiotherapy dosimetry. The purpose here is to adapt this already existing technology to provide a novel dosimeter for radiotherapy measurements. The proposed real-time dosimeter consists of twenty 4 mm-long FBGs, equally distributed over 20 cm. FBGs are written through the coating of a standard polyimide-coated silica fiber with the phase-mask technique and femtosecond pulses. The wavelength dependant variation of each FBG is recorded at 1 kHz with a commercially available interrogator. The use of gamma radiation (clinical radiotherapy accelerator) induces a linear shift (0.070 ± 0.006 pm/Gy) of the FBG’s reflected wavelength, which is independent of the dose rates (2.8-11.6 Gy/min) and the energy (6-23 MV). A statistical error of 0.03 pm is obtained on data points therefore limiting the detectable dose to 0.4 Gy. A dose profile of 6 and 23 MV radiotherapy accelerator is also measured. The presented FBGs dosimeter allows for real-time dose measurement in 2D and the small size of its detector makes it a versatile tool. The length and spacing of FBGs can be easily modified to increase both the spatial resolution and the amount of dose point.

The interest in fiber Bragg gratings dosimeters for radiotherapy dosimetry lies in their (i) submillimeter size, (ii) multi-points dose measurements, and (iii) customizable spatial resolution. However, since the radiation measurement relies on the thermal expansion of the surrounding polymer coating, such sensors are strongly temperature dependent, which needs to be accounted for; otherwise, the errors on measurements can be higher than the measurements themselves. In this paper, we test and compare four techniques for temperature compensation: two types of dual grating techniques using different coatings, a pre-irradiation and post-irradiation temperature drift technique, which is used for calorimetry, and finally, we developed a real-time interpolated temperature gradient for the multi-points dosimetry technique. We show that, over these four tested techniques, the last one outperforms the others and allows for real-time temperature correction when an array of 13 fiber Bragg gratings spatially extending over the irradiation zone is used. For a 20 Gy irradiation, this technique reduces the measurement errors from 200% to about 10%, making it suitable for a radiotherapy dose range. Temperature correction for medical low-dose range dosimetry is a first in our field and is essential for clinical FBG dosimetry applications.

We report on an ytterbium-free, erbium-doped single-mode all-fiber laser reaching a record output power of 107 W at 1598 nm, with a slope efficiency of 38.6% according to the absorbed pump power at 981 nm. The erbium-doped gain fiber, co-doped with cerium, aluminum, and phosphorus, was fabricated in-house with adjusted doping concentrations to reduce erbium ions clustering, thereby increasing efficiency while keeping the numerical aperture low to ensure a single-mode laser operation. The addition of cerium co-dopant in the core glass of an erbium system is used for the first time, to the best of our knowledge, in order to adjust the fiber’s numerical aperture without increasing the erbium concentration. Numerical modeling, validated by the experimental results, demonstrates that adding aluminum and phosphorus at high concentration mitigates erbium ions clustering, with an estimated erbium paired ions of only 5.0% in the reported gain fiber.