The Australian Community Climate and Earth System Simulator coupled model (ACCESS-CM) has been developed at the Centre for Australian Weather and Climate Research (CAWCR), a partnership between CSIRO 1 and the Bureau of Meteorology. It is built by coupling the UK Met Office atmospheric unified model (UM), and other sub-models as required, to the ACCESS ocean model, which consists of the NOAA/GFDL 2 ocean model MOM4p1 and the LANL 3 sea-ice model CICE4.1, under the CERFACS 4 OASIS3.2-5 coupling framework. The primary goal of the ACCESS-CM development is to provide the Australian climate community with a new generation fully coupled climate model for climate research, and to participate in phase five of the Coupled Model Inter-comparison Project (CMIP5). This paper describes the ACCESS-CM framework and components, and presents the control climates from two versions of the ACCESS-CM, ACCESS1.0 and AC-CESS1.3, together with some fields from the 20 th century historical experiments, as part of model evaluation. While sharing the same ocean sea-ice model (except different setups for a few parameters), ACCESS1.0 and ACCESS1.3 differ from each other in their atmospheric and land surface components: the former is configured with the UK Met Office HadGEM2 (r1.1) atmospheric physics and the Met Office Surface Exchange Scheme land surface model version 2, and the latter with atmospheric physics similar to the UK Met Office Global Atmosphere 1.0 including modifications performed at CAWCR and the CSIRO Community Atmosphere Biosphere Land Exchange land surface model version 1.8. The global average annual mean surface air temperature across the 500-year preindustrial control integrations show a warming drift of 0.35 °C in ACCESS1.0 and 0.04 °C in AC-CESS1.3. The overall skills of ACCESS-CM in simulating a set of key climatic fields both globally and over Australia significantly surpass those from the preceding CSIRO Mk3.5 model delivered to the previous coupled model inter-comparison. However, ACCESS-CM, like other CMIP5 models, has deficiencies in various aspects, and these are also discussed.

The ability of 15 atmospheric GCM models (AGCM) to simulate the tropical intraseasonal oscillation has been studied as part of AMIP. Time series of the daily upper tropospheric velocity potential and zonal wind, averaged over the equatorial belt, were provided from each AGCM simulation. These data were analyzed using a variety of techniques such as time filtering and space-time spectral analysis to identify eastward and westward propagating waves. The results have been compared with an identical assessment of ECMWF analyses for the period 1982-1991. The models display a wide range of skill in simulating the intraseasonal oscillation. Most models show evidence of an eastward propagating anomaly in the velocity potential field, although in some models there is a greater tendency for a standing oscillation, and in one or two the field is rather chaotic with no preferred direction of propagation. Where a model has a clear eastward propagating signal, typical periodicities seem quite reasonable although there is a tendency for the models to simulate shorter periods than in the ECMWF analyses, where it is near 50 days. The results of the space-time spectral analysis have shown that no model has captured the dominance of the intraseasonal oscillation found in the analyses. Several models have peaks at intraseasonal time scales, but nearly all have relatively more power at higher frequencies

There is ample evidence that anthropogenic aerosols have important effects on climate in the Northern Hemisphere but little such evidence in the Southern Hemisphere. Observations of Australian rainfall and cloudiness since 1950 show increases over much of the continent. We show that including anthropogenic aerosol changes in 20th century simulations of a global climate model gives increasing rainfall and cloudiness over Australia during 1951–1996, whereas omitting this forcing gives decreasing rainfall and cloudiness. The pattern of increasing rainfall when aerosols are included is strongest over northwestern Australia, in agreement with the observed trends. The strong impact of aerosols is primarily due to the massive Asian aerosol haze, as confirmed by a sensitivity test in which only Asian anthropogenic aerosols are included. The Asian haze alters the meridional temperature and pressure gradients over the tropical Indian Ocean, thereby increasing the tendency of monsoonal winds to flow toward Australia. Anthropogenic aerosols also make the simulated pattern of surface‐temperature change in the tropical Pacific more like La Niña, since they induce a cooling of the surface waters in the extratropical North Pacific, which are then transported to the tropical eastern Pacific via the deep ocean. Transient climate model simulations forced only by increased greenhouse gases have generally not reproduced the observed rainfall increase over northwestern and central Australia. Our results suggest that a possible reason for this failure was the omission of forcing by Asian aerosols. Further research is essential to more accurately quantify the role of Asian aerosols in forcing Australian climate change.

Abstract. The Scenario Model Intercomparison Project (ScenarioMIP) defines and coordinates the main set of future climate projections, based on concentration-driven simulations, within the Coupled Model Intercomparison Project phase 6 (CMIP6). This paper presents a range of its outcomes by synthesizing results from the participating global coupled Earth system models. We limit our scope to the analysis of strictly geophysical outcomes: mainly global averages and spatial patterns of change for surface air temperature and precipitation. We also compare CMIP6 projections to CMIP5 results, especially for those scenarios that were designed to provide continuity across the CMIP phases, at the same time highlighting important differences in forcing composition, as well as in results. The range of future temperature and precipitation changes by the end of the century (2081–2100) encompassing the Tier 1 experiments based on the Shared Socioeconomic Pathway (SSP) scenarios (SSP1-2.6, SSP2-4.5, SSP3-7.0 and SSP5-8.5) and SSP1-1.9 spans a larger range of outcomes compared to CMIP5, due to higher warming (by close to 1.5 ∘C) reached at the upper end of the 5 %–95 % envelope of the highest scenario (SSP5-8.5). This is due to both the wider range of radiative forcing that the new scenarios cover and the higher climate sensitivities in some of the new models compared to their CMIP5 predecessors. Spatial patterns of change for temperature and precipitation averaged over models and scenarios have familiar features, and an analysis of their variations confirms model structural differences to be the dominant source of uncertainty. Models also differ with respect to the size and evolution of internal variability as measured by individual models' initial condition ensemble spreads, according to a set of initial condition ensemble simulations available under SSP3-7.0. These experiments suggest a tendency for internal variability to decrease along the course of the century in this scenario, a result that will benefit from further analysis over a larger set of models. Benefits of mitigation, all else being equal in terms of societal drivers, appear clearly when comparing scenarios developed under the same SSP but to which different degrees of mitigation have been applied. It is also found that a mild overshoot in temperature of a few decades around mid-century, as represented in SSP5-3.4OS, does not affect the end outcome of temperature and precipitation changes by 2100, which return to the same levels as those reached by the gradually increasing SSP4-3.4 (not erasing the possibility, however, that other aspects of the system may not be as easily reversible). Central estimates of the time at which the ensemble means of the different scenarios reach a given warming level might be biased by the inclusion of models that have shown faster warming in the historical period than the observed. Those estimates show all scenarios reaching 1.5 ∘C of warming compared to the 1850–1900 baseline in the second half of the current decade, with the time span between slow and fast warming covering between 20 and 27 years from present. The warming level of 2 ∘C of warming is reached as early as 2039 by the ensemble mean under SSP5-8.5 but as late as the mid-2060s under SSP1-2.6. The highest warming level considered (5 ∘C) is reached by the ensemble mean only under SSP5-8.5 and not until the mid-2090s.

Six years ago, we compared the climate sensitivity of 19 atmospheric general circulation models and found a roughly threefold variation among the models; most of this variation was attributed to differences in the models' depictions of cloud feedback. In an update of this comparison, current models showed considerably smaller differences in net cloud feedback, with most producing modest values. There are, however, substantial differences in the feedback components, indicating that the models still have physical disagreements