Careful tracing of evidence at the site of a crime must be performed before suspects can be convicted of a crime or homicide. Fingerprints and ballistic control samples are important evidence. A common method used to examine lead bullets is comparison of physical properties such as weight, dimensions, shape, and distinctive markings. However ballistic investigations, for example comparison of characteristic scratches and marks left on fired bullets, do not always give sufficient information. Ballistic abrasion patterns can change for a variety of reasons, e.g. deformation or mechanical strain. Sometimes only particles remain in a victim's body. In such cases trace-element composition and lead-isotope ratios can be compared with those of controls. Elemental composition of particles and deformed bullets have been compared with the elemental fingerprints and isotope ratios of potential bullet types found on suspects. The applicability of the method was studied for two different cases. Data interpretation and several limitations of the technique are also discussed in this paper.

The installation of wood pellet heating as a cost-effective and climatically neutral source of energy for private households has increased steadily in recent years. We report two deaths that occurred within the space of about a year in wood pellet storerooms of private households in German-speaking countries and were investigated by forensic medical teams. This is the first report of fatalities in this special context as is shown in the literature review. Both victims died of carbon monoxide (CO) poisoning; one of the victims was a woman who was 4 months pregnant. Measurements at the scene detected life-threatening CO concentrations (7500 ppm, >500 ppm), which were not significantly reduced after ventilation of the storerooms as required by regulations. We carried out a series of experiments in order to confirm CO production by wood pellets. Thirty kilograms of freshly produced pellets from two different manufacturers were stored for 16 days in airtight containers at 26°C with different relative humidities. CO concentrations between 3100 and 4700 ppm were measured in all containers. There were no notable differences between the wood pellet products or storage at different humidities. Emission of CO from wood pellets has already been described, but fatal accidents have previously been reported only in association with pellet transport on cargo ships or storage in silos. It is therefore a new finding that fatal accidents may also occur in the wood pellet storerooms of private households. We show that significant CO concentrations can build up even when these rooms are ventilated in accordance with the regulations and that such levels may cause the death of healthy persons, as described in the following. As the safety recommendations from the wood pellet industry are inadequate, we consider that further fatal accidents are likely to occur and recommend urgent revision of the safety regulations.

In conclusion, the location of a bullet, and its orientation toward the gantry must be taken into account when assessing the risk of performing an MR examination on a gunshot victim in clinical and in forensic cases.