Light-harvesting antenna core (LH1-RC) complexes isolated from Rhodoseudomonas palustris were self-assembled on a gold electrode modified with self-assembled monolayers (SAMs) of the alkanethiols NH2(CH2)nSH, n = 2, 6, 8, 11; HOOC(CH2)7SH; and CH3(CH2)7SH, respectively. Adsorption of the LH1-RC complexes on the SAMs depended on the terminating group of the alkanethiols, where the adsoption increased in the following order for the terminating groups: amino groups > carboxylic acid groups > methyl groups. Further, the adsorption on a gold electrode modified with SAMs of NH2(CH2)nSH, n = 2, 6, 8, 11, depended on the methylene chain length, where the adsorption increased with increasing the methylene chain length. The presence of the well-known light-harvesting and reaction center peaks of the near infrared (NIR) absorption spectra of the LH1-RC complexes indicated that these complexes were only fully stable on the SAM gold electrodes modified with the amino group. In the case of modification with the carboxyl group, the complexes were partially stable, while in the presence of the terminal methyl group the complexes were extensively denatured. An efficient photocurrent response of these complexes on the SAMs of NH2(CH2)nSH, n = 2, 6, 8, 11, was observed upon illumination at 880 nm. The photocurrent depended on the methylene chain length (n), where the maximum photocurrent response was observed at n = 6, which corresponds to a distance between the amino terminal group in NH2(CH2)6SH and the gold surface of 1.0 nm.

A polyhistidine (His) tag was fused to the C- or N-terminus of the light-harvesting (LH1)-α chain of the photosynthetic antenna core complex (LH1-RC) from Rhodobacter sphaeroides to allow immobilization of the complex on a solid substrate with defined orientation. His-tagged LH1-RCs were adsorbed onto a gold electrode modified with Ni-NTA. The LH1-RC with the C-terminal His-tag (C-His LH1-RC) on the modified electrode produced a photovoltaic response upon illumination. Electron transfer is unidirectional within the RC and starts when the bacteriochlorophyll a dimer in the RC is activated by light absorbed by LH1. The LH1-RC with the N-terminal His-tag (N-His LH1-RC) produced very little or no photocurrent upon illumination at any wavelength. The conductivity of the His-tagged LH1-RC was measured with point-contact current imaging atomic force microscopy, indicating that 60% of the C-His LH1-RC are correctly oriented (N-His 63%). The oriented C-His LH1-RC or N-His LH1-RC showed semiconductive behavior, that is, had the opposite orientation. These results indicate that the His-tag successfully controlled the orientation of the RC on the solid substrate, and that the RC produced photocurrent depending upon the orientation on the electrode.

A functional linkage between light-harvesting and photocatalytic components is a pivotal issue for using solar energy in chemical conversions; however, this concept is far from being practically realized. Here, we constructed a system that integrates an artificially extended photosynthetic light-harvesting complex 2 (LH2) and a light-harvesting 1-reaction center (RC) core complex (LH1-RC). A biohybrid LH2, whose light-harvesting ability was extended by a covalently attached hydrophobic fluorophore ATTO647N (LH2-ATTO) to cover the absorption gap of LH2, was assembled with LH1-RC in a lipid bilayer. Femtosecond transient absorption spectroscopy revealed that upon an excitation of the ATTO, sequential excitation energy transfer (EET), ATTO → LH2 → LH1 → RC, was followed by a subsequent electron transfer in the RC with rates comparable to those in a native system. As a proof of concept, the functional linkage between light-harvesting and photocatalytic reactions was quantitatively demonstrated through the enhancement in the charge separation yield and photocurrent generation activity of LH2-ATTO/LH1-RC assembled on an electrode.