The development of efficient proton conductors that are capable of high power density, sufficient mechanical strength, and reduced gas permeability is challenging. Herein, we report the development of a series of aromatic sulfonic acid/graphene oxide hybrid membranes incorporating benzene sulfonic acid (BS), naphthalene sulfonic acid (NS), naphthalene disulfonic acid (DS) or pyrene sulfonic acid (PS) using a facile freeze dried method. For out-of-plane proton conductivity, the 3DGO-BS and 3DGO-NS yielded proton conductivities of 4.4 × 10 À 2 S cm À 1 and 3.1 × 10 À 2 S cm À 1 , respectively; this represents a two-times higher value than that which occurs for three dimensional graphene oxide (3DGO). Additionally, the respective prepared films as membranes in a proton exchange membrane fuel cell (PEMFC) show maximum power density of 98.76 mW cm À 2 for 3DGO-NS while it is 92.75 mW cm À 2 for 3DGO-BS which are close to double that obtained for 3DGO (50 mW cm À 2 ).[a] M.

Herein, we report an efficient proton exchange membrane formed from a synergistic combination of graphene oxide (GO) and oxidized single-walled carbon nanotube (CNTOX) by the freeze-drying route that gives rise to enhanced fuel cell power density. At 25 °C and 100% relative humidity (RH), the 3DGO-CNTOX hybrid shows remarkably high out-of-plane and in-plane proton conductivities of 6.64 × 10 À 2 and 5.08 S cm À 1 , respectively. Additionally, the measured performance using prepared films as proton conduction membranes in a proton exchange membrane fuel cell (PEMFC) exhibited a peak power density of 117.21 mW cm À 2 . The high performance of these films can be ascribed to the freeze-dried-driven structural morphology of 3DGO-CNTOX that facilitates higher water retention capacity as well as the synergistic strengthening effect between GO and CNTOX with a highly interconnected proton conduction network. The current results imply that the new 3DGO-CNTOX hybrid material has potential for wide application as a proton exchange membrane.[a] M.