We report measurements of the product yield for nitryl chloride (ClNO2) production following the reactive uptake of dinitrogen pentoxide (N2O5) to a wide variety of ambient seawater samples as well as seawater mimics. The ClNO2 yield, as measured for ambient seawater collected from both coastal and open ocean waters, was found to be both insensitive to chlorophyll-a, a marker for biological activity, and significantly lower (0.16-0.30) than that expected for equivalent salt-containing solutions (0.82 ± 0.05). Suppression in the ClNO2 yield can be induced by the addition of aromatic organic compounds (e.g., phenol and humic acid) to synthetic seawater matrices. In the case of phenol, surface tension measurements reveal that the surface phenol:chloride ratio can be enhanced by more than a factor of 100 as compared to bulk ratios for subtle changes in surface tension (<1.5 mN m(-1)), providing a mechanism to suppress ClNO2 production at low bulk phenol concentrations. We interpret measurements of the dependence of the ClNO2 yield on phenol using a kinetic model, where we confine the surface enhancement in phenol to the top 1 nm of the interface. Our results are most consistent with a model where N2O5 is ionized within the first three water monolayers (<1 nm), where the product nitronium ions react rapidly with interfacial phenol molecules. These results suggest that ClNO2 may not be formed at the air-sea interface at the yield expected for NaCl, and that the reactive uptake of N2O5 and the subsequent product yield of ClNO2 may serve as a unique probe for the composition of the interfacial region of the sea surface microlayer.

Gas-liquid scattering and product-yield experiments are used to investigate reactions of NO with glycerol containing Br and surfactant ions. NO oxidizes Br to Br for every solution tested: 2.7 M NaBr, 0.03 M tetrahexylammonium bromide (THABr), 0.03 M THABr + 0.5 M NaBr, 0.03 M THABr + 0.5 M NaCl, 0.03 M THABr + 0.01 M sodium dodecyl sulfate (SDS), and 0.01 M cetyltrimethylammonium bromide (CTABr). NO also reacts with glycerol itself to produce mono- and dinitroglycerin. Surface tension measurements indicate that 0.03 M THABr and 2.7 M NaBr have similar interfacial Br concentrations, though their bulk Br concentrations differ by 90-fold. We find that twice as much Br is produced in the presence of THA, implying that the conversion of Br to Br is initiated at the interface, perhaps mediated by the charged, hydrophobic pocket within the surface THA cation. The addition of 0.5 M NaBr, 0.5 M NaCl, or 0.01 M SDS to 0.03 M THABr lowers the Br production rate by 23%, 63%, and 67% of the THABr value, respectively. When CTA is substituted for THA, Br production drops to 12% of the THABr value. The generation of Br under such different conditions implies that trace amounts of surface-active alkylammonium ions can catalyze interfacial NO reactions, even when salts and other surfactants are present.

Transient infrared absorption spectroscopy monitors condensed-phase photodissociation dynamics of 30 mM CHBr3 and 50 mM CHI3 in liquid CCl4. The experiments have picosecond time resolution and monitor the C-H stretch region of both the parent polyhalomethanes and their photolytically generated isomers. The C-H stretching transitions of these isomers, in which the emergent halogen atom returns to form a C-X-X bonding motif, appear about 9 ps after photolysis for iso-CHBr2-Br and in about 46 ps for iso-CHI2-I. These time scales are consistent with, but differ from, the time evolution of the transient electronic absorption spectra of the same samples, highlighting the subtle differences between monitoring the vibrational and electronic chromophores. The specificity of using vibrational transitions to track condensed-phase reaction dynamics permits reassessment of the transient electronic spectrum of photolysis in neat CHBr3, which has an additional prompt feature near 400 nm. Calculations show that this feature, which arises from a precursor to the isomer, is a charge-transfer transition of a contact pair between the nascent Br fragment and a nearby CHBr3 molecule. Dilution and solvent studies show that transition is independent of the solvent. The iso-CHBr2-Br transition wavelength, however, shifts over the range of 400 to 510 nm depending on the solvent. Time-dependent density functional calculations faithfully reproduce these trends.

Gas-liquid scattering experiments were employed to measure the entry and dissociation of the acidic gas DCl into salty glycerol coated with dodecyl sulfate ions (DS(-) = CH3(CH2)11OSO3(-)). Five sets of salty solutions were examined: 0.25 and 0.5 M NaCl, 0.25 M MgCl2, 0.25 M CaCl2, and artificial sea salt. DS(-) bulk concentrations were varied from 0 to 11 mM, generating DS(-) surface coverages of up to 34% of a compact monolayer, as determined by surface tension and argon scattering measurements. DS(-) surface segregation is enhanced by the dissolved salts in the order MgCl2 ≈ CaCl2 > sea salt > NaCl. We find that DCl penetration through the dodecyl chains decreases at first gradually and then sharply as more chains segregate to the surface, dropping from 70% entry on bare glycerol to 11% for DS(-) surface concentrations of 1.8 × 10(14) cm(-2). When plotted against DS(-) surface concentration, the DCl entry probabilities fall within a single band for all solutions. These observations imply that the monovalent Na(+) and divalent Ca(2+) and Mg(2+) ions do not bind differently enough to the ROSO3(-) headgroup to significantly alter the diffusive passage of DCl molecules through the dodecyl chains at the same DS(-) chain density. The chief difference among the salts is the greater propensity for the divalent salts to expel the soluble ionic surfactant to the surface.

We present evidence for vibrational enhancement of the rate of bimolecular reactions of Br atoms with dimethylsulfoxide (DMSO) and methanol (CHOH) in the condensed phase. The abstraction of a hydrogen atom from either of these solvents by a Br atom is highly endoergic: 3269 cm for DMSO and 1416 or 4414 cm for CHOH, depending on the hydrogen atom abstracted. Thus, there is no thermal abstraction reaction at room temperature. Broadband electronic transient absorption shows that following photolysis of bromine precursors Br atoms form van der Waals complexes with the solvent molecules in about 5 ps and this Br-solvent complex undergoes recombination. To explore the influence of vibrational energy on the abstraction reactions, we introduce a near-infrared (NIR) pump pulse following the photolysis pulse to excite the first overtone of the C-H (or O-H) stretch of the solvent molecules. Using single-wavelength detection, we observe a loss of the Br-solvent complex that requires the presence of both photolysis and NIR pump pulses. Moreover, the magnitude of this loss depends on the NIR wavelength. Although this loss of reactive Br supports the notion of vibrationally driven chemistry, it is not concrete evidence of the hydrogen-abstraction reaction. To verify that the loss of reactive Br results from the vibrationally driven bimolecular reaction, we examine the pH dependence of the solution (as a measure of the formation of the HBr product) following long-time irradiation of the sample with both photolysis and NIR pump beams. We observe that when the NIR beam is on-resonance, the hydronium ion concentration increases fourfold as compared to that when it is off-resonance, suggesting the formation of HBr via a vibrationally driven hydrogen-abstraction reaction in solution.