Cardiovascular disease of major and minor arteries is a common cause of death in Western society. The wall mechanics and haemodynamics within the arteries are considered to be important factors in the disease formation process. This paper is concerned with the development of an efficient computer-integrated technique to manufacture idealized and realistic models of diseased major and minor arteries from radiological images and to address the issue of model wall thickness variability. Variations in wall thickness from the original computer models to the final castings are quantified using a CCD camera. The results found that wall thickness variation from the major and minor idealized artery models to design specification were insignificant, up to a maximum of 16 per cent. In realistic models, however, differences were up to 23 per cent in the major arterial models and 58 per cent in the minor arterial models, but the wall thickness variability remained within the limits of previously reported wall thickness results. It is concluded that the described injection moulding procedure yields idealized and realistic castings suitable for use in experimental investigations, with idealized models giving better agreement with design. Wall thickness is variable and should be assessed after the models are manufactured.
A range of silicone rubbers were created based on existing commercially available materials. These silicones were designed to be visually different from one another and have distinct material properties, in particular, ultimate tensile strengths and tear strengths. In total, eleven silicone rubbers were manufactured, with the materials designed to have a range of increasing tensile strengths from approximately 2-4MPa, and increasing tear strengths from approximately 0.45-0.7N/mm. The variations in silicones were detected using a standard colour analysis technique. Calibration curves were then created relating colour intensity to individual material properties. All eleven materials were characterised and a 1st order Ogden strain energy function applied. Material coefficients were determined and examined for effectiveness. Six idealised abdominal aortic aneurysm models were also created using the two base materials of the study, with a further model created using a new mixing technique to create a rubber model with randomly assigned material properties. These models were then examined using videoextensometry and compared to numerical results. Colour analysis revealed a statistically significant linear relationship (p<0.0009) with both tensile strength and tear strength, allowing material strength to be determined using a non-destructive experimental technique. The effectiveness of this technique was assessed by comparing predicted material properties to experimentally measured methods, with good agreement in the results. Videoextensometry and numerical modelling revealed minor percentage differences, with all results achieving significance (p<0.0009). This study has successfully designed and developed a range of silicone rubbers that have unique colour intensities and material strengths. Strengths can be readily determined using a nondestructive analysis technique with proven effectiveness. These silicones may further aid towards an improved understanding of the biomechanical behaviour of aneurysms using experimental techniques.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.