The use of three-dimensional (3D) facial scans for facial analysis is increasing in maxillofacial treatment. The aim of this study was to investigate the consistency of two-dimensional (2D) and 3D facial analyses performed by multiple raters. Six men and four women (25–36-year-old) participated in this study. The 2D images of the smiling and resting faces in the frontal and sagittal planes were obtained. The 3D facial and intraoral scans were merged to generate virtual 3D faces. Ten clinicians performed facial analyses by investigating 14 indices of 2D and 3D faces. Intra- and interrater agreements of the results of 2D and 3D facial analyses within and among the participants were evaluated. The intrarater agreement between the 2D and 3D facial analyses varied according to the indices. The highest and lowest agreements were found for the dental crowding index (0.94) and smile line curvature index (0.56) in the frontal plane, and Angle’s classification (canine) index (0.98) and occlusal plane angle index (0.55) in the profile plane. In the frontal plane, the interrater agreements were generally higher for the 3D images than for the 2D images, while in the profile plane, the interrater agreements were high in the Angle’s classification (canine) index however low in the other indices. Several occlusion-related indices were missing in the 2D images because the posterior teeth were not observed. Esthetic analysis results between 2D and 3D face images can differ according to the evaluation indices. The use of 3D faces is recommended over 2D images to increase the reliability of facial analyses, as it can fully assess both esthetic and occlusion-related indices.

A 78-year-old female patient presented with implant failure in the maxillary and mandibular anterior areas due to medication-related osteonecrosis of the jaw. Implant-supported fixed dental prosthesis (FDP) in the maxilla and mandible were removed, and implants with osteomyelitis were removed in the anterior area (three implants in the maxilla and two implants in the mandible). After the healing period, the maxillary anterior area was recovered with 6-unit implant-supported FDP, and the mandible was reconstructed using an implant-supported double-crown-retained removable denture with friction pins. The patient was satisfied with the functionality and maintenance of the new prostheses.