The depletion of fossil fuels as well as the rises of greenhouse gases had caused most government worldwide to follow the international energy policies for the use of biodiesel. One of the economical sources for biodiesel production is waste cooking oil. The use of waste cooking oil is more sustainable if they can perform similarly to conventional diesel fuel. This paper deals with the experimental study carried out to evaluate the engine performance and exhaust emission of diesel engine operated by biodiesel from waste cooking oil at various engine speed. The biodiesel used are known as B5, which contains of 5% of waste cooking oil and 95% of diesel fuel. The other one is B20, which contains of 20% of waste cooking oil plus 80% of diesel. Diesel was used as a comparison purposes. The results show that power and torque for B5 give the closest trend to diesel. In terms of heat release, diesel still dominates the highest value compared to B5 and B20. For exhaust emission, B5 and B20 showed improvement in the reduction of NOx and PM.

Abstract:The increase of industrial activities and motor vehicles globally causes rise demands in fossil fuel as energy sources. Since fossil fuel is non-renewable energy, many researches have been conducted to reduce the reliance to this fossil fuel. In conjunction, the number of waste plastic and tires around the world is increasing as a result of modern application and increasing number of motor vehicle. This type of waste is hard to decays and commonly dumped onto open landfills. Utilization of waste tires and plastics can produce alternative fuel that potentially can be used in diesel engine. In this paper, the combustion characteristics of two waste source fuels known as waste plastic disposal fuel (WPDF) and tire disposal fuel (TDF) are discussed. The combustion characteristics of both fuels are compared to diesel fuel. WPDF and TDF used in this experiment are pure concentrated and not blended with diesel fuel. The experiment is conducted using single cylinder YANMAR TF120M diesel engine. The engine is operated at constant load at 20 Nm and variable speed ranged from 1200 rpm to 2400 rpm. The combustion characteristics that discussed in this paper are ignition delay and peak pressure. Both characteristic are measured at two engine speed region which is low speed (1200 rpm) and high speed (2100 rpm). From the results obtained, it can be observed that WPDF has comparable ignition delay compared to diesel fuel while TDF has longest ignition delay compared to WPDF and diesel fuel. TDF also produce highest peak pressure compared to other tested fuels. Moreover, TDF is not suitable for high speed application since it cause backfire when engine speed reach 2200 rpm.

No abstract

Abstract. Particulate matter (PM) is one of the major pollutants emitted by diesel engine which have adverse effects on human health. Accordingly, many researches have been done to find alternative fuels that are clean and efficient. Biodiesel is preferred as an alternative source for diesel engine which produces lower PM than diesel fuel. However, the manufacturing cost of biodiesel from vegetable oil is expensive. Therefore, using waste cooking oil (WCO) for biodiesel would be more economical and sustainable solution. The characteristics of direct injection diesel engine in term of the PM have been investigated experimentally in this study. The experiments were conducted using single cylinder diesel engine with different speed (1200 rpm, 1500 rpm, 1800 rpm, 2100 rpm, 2400 rpm) at constant load. PM emission of WCO B100 and diesel fuel was compared and the effect of PM components such as soluble organic fraction (SOF) and soot were studied. The result showed WCO B100 reduces the PM emission at all engine speed. Furthermore, both fuels showed highest reduction of PM concentration at moderate engine speed of 1500 rpm.

Response surface methodology based prediction of engine performance and exhaust emissions of a diesel engine fuelled with canola oil methyl ester J. Renewable Sustainable Energy 5, 033132 (2013); 10.1063/1.4811801Performance and emission evaluation of biodiesel fueled diesel engine abetted with exhaust gas recirculation and Ni coated catalytic converter A comparative evaluation of Al 2 O 3 coated low heat rejection diesel engine performance and emission characteristics using fuel as rice bran and pongamia methyl ester J. Renewable Sustainable Energy 2, 053105 (2010); 10.1063/1.3480659Investigations on emission characteristics of the pongamia biodiesel-diesel blend fuelled twin cylinder compression ignition direct injection engine using exhaust gas recirculation methodology and dimethyl carbonate as additive Abstract. Optimization of using waste plastic and tire disposal fuel on diesel engine were observed. The experimental project was comparison between using both of unconventional fuel and base diesel fuel. The engine experiment was conducted with YANMAR TF120 single cylinder four stroke diesel engine set-up at variable engine speed at 2100, 1900, 1700, 1500 and 1300 rpm. The data have been taken at each point of engine speed during the stabilized engine-operating regime. Measurement of emissions parameters at different engine speed conditions have generally indicated lower in emission CO for waste plastic fuel, lower NO x for tire disposal fuel and lower SO x for diesel fuel.