No abstract

Microfiltration flat sheet membranes of polyether sulfone (PES) were fabricated by incorporating varying concentrations of polymer and investigated the influence of substituting solvents. The membranes were prepared via immersion precipitation method. Different solvents that included NMP (N-methyl-2-pyrrolidone), DMF (dimethylformamide), and THF (tetrahydrofuran) were used to analyse their effect on the performance and morphology of the prepared membranes. Two different coagulation bath temperatures were used to investigate the kinetics of membrane formation and subsequent effect on membrane performance. The maximum water flux of 141 ml/cm2.h was observed using 21% of PES concentration in NMP + THF cosolvent system. The highest tensile strength of 29.15 MPa was observed using membrane prepared with 21% PES concentration in NMP as solvent and coagulation bath temperature of 25°C. The highest hydraulic membrane resistance was reported for membrane prepared with 21% PES concentration in NMP as solvent. Moreover, the lowest contact angle of 67° was observed for membrane prepared with 15% of PES concentration in NMP as solvent with coagulation bath temperature of 28°C. Furthermore, the Hansen solubility parameter was used to study the effect on the thermodynamics of membrane formation and found to be in good correlation with experimental observation and approach in the present work.

The present work is focused on preparation, characterization, and antibacterial activity evaluation of graphene oxide/polyethersulfone mixed matrix filtration membranes. Graphene oxide (GO) was synthesized via improved Hummer’s method and characterized by XRD, FTIR, and SEM. FT-IR spectra showed the presence of carboxylic acid and hydroxyl groups on GO nanosheets. Different concentrations of the synthesized GO at 0.25, 0.5, and 1.0 wt. % were incorporated in polyethersulfone (PES) matrix via phase inversion method to fabricate GO-PES membranes. Increasing porosity and formation of wider, finger-like channels were observed with increased GO concentrations relative to pristine membranes as evident from scanning electron microscopy (SEM) micrographs of the fabricated membranes. However, membranes prepared with 1 wt. % GO appear to contain aggregation and narrowing of pore morphology. GO-incorporated membranes demonstrated enhanced flux, water-retaining capacities, and wettability as compared to pristine PES membranes. Shake flask and colony counting methods were employed to carry out antibacterial testing of synthesized GO and fabricated GO-PES membranes against Salmonella typhi (S. typhi)—a gram-negative bacteria present in water that is known as causative agent of typhoid. Synthesized GO showed significant reduction up to 70.8% in S. typhi cell count. In the case of fabricated membranes, variable concentrations of GO are observed to significantly influence the percentage viability of S. typhi, with reduction percentages observed at 41, 60, and 69% for 0.25, 0.5, and 1.0 wt. % GO-incorporated membranes relative to 17% in the case of pristine PES membranes. The results indicate a good potential for applying GO/PES composite membranes for water filtration application.