Low-voltage battery energy storage system and dual active bridge (DAB) converter control method for DC bus connection in DC microgrid. To use power efficiently in a DC microgrid, power must be easily transferred in both directions. DAB converters can easily transfer power in both directions using only the phase shift of the gate at 50% fixed duty on the primary and secondary sides. In the transient state, however, an overcurrent occurs to charge the output capacitor. A soft start algorithm is used to overcome this overcurrent problem. In the conventional method, the control complexity and response characteristics are slow because the duty control is included and the algorithm is performed in several stages. In this study, a gate drive circuit is constructed using a pulse transformer for 50% fixed duty control and short circuit protection. A soft start control algorithm is proposed, including a first-order phase shift scheme for the stable soft start at 50% fixed duty. The 3 kW prototype DAB converter is designed and implemented for bidirectional power conversion testing. The experimental results show that stable power transfer is achieved in the initial transient state through bidirectional output control and soft start.

In this paper, an add-on type pulse charger is proposed to shorten the charging time of a lithium ion battery. To evaluate the performance of the proposed pulse charge method, an add-on type pulse charger prototype is designed and implemented. Pulse charging is applied to 18650 cylindrical lithium ion battery packs with 10 series and 2 parallel structures. The proposed pulse charger is controlled by pulse duty, frequency and magnitude. Various experimental conditions are applied to optimize the charging parameters of the pulse charging technique. Battery charging data are analyzed according to the current magnitude and duty at 500 Hz and 1000 Hz and 2000 Hz frequency conditions. The proposed system is similar to the charging speed of the constant current method under new battery conditions. However, it was confirmed that as the battery performance is degraded, the charging speed due to pulse charging increases. Thus, in applications where battery charging/discharging occurs frequently, the proposed pulse charger has the advantage of fast charging in the long run over conventional constant current (CC) chargers.

No abstract

This paper presents a frequency adaptive grid voltage sensorless control scheme of a grid-connected inductive–capacitive–inductive (LCL)-filtered inverter, which is based on an adaptive current controller and a grid voltage observer. The frequency adaptive current controller is constructed by a full-state feedback regulator with the augmentation of multiple control terms to restrain not only the inherent resonance phenomenon that is caused by LCL filter, but also current harmonic distortions from an adverse grid environment. The number of required sensing devices is minimized in the proposed scheme by means of a discrete-time current-type observer, which estimates the system state variables, and gradient-method-based observers, which estimate the grid voltages and frequency simultaneously at different grid conditions. The estimated grid frequency is utilized in the current control loop to provide high-quality grid-injected currents, even under harmonic distortions and the frequency variation of grid voltages. As a result, the grid frequency adaptive control performance as well as the robustness against distorted grid voltages can be realized. Finally, an inverter synchronization task without using grid voltage sensors is accomplished by a fundamental grid voltage filter and a phase-locked loop to detect the actual grid phase angle. The stability and convergence performance of the proposed observers have been studied by means of the Lyapunov theory to ensure a high accuracy tracking performance of estimated variables. Simulation and experimental results are presented to validate the feasibility and the effectiveness of the proposed control approach.

No abstract