We report a photonic technique to instantaneously synthesize cobalt oxide reduced graphitic oxide (CoOx-rGO) supercapacitor electrodes. The electrode processing is achieved through rapidly heating the precursor material by irradiation of high-energy pulsed mostly visible light from a xenon lamp. Due to the short duration of the light pulse, we prepared the electrodes at room temperature instantaneously (ms), thus eliminating the several hours of processing times of the conventional techniques. The as-prepared electrodes exhibited a highly porous morphology, allowing for enhanced ionic transport during electrochemical interactions. The electrochemical properties of the CoOx-rGO electrodes were studied in 1 M KOH aqueous electrolyte. The non-rectangular cyclic voltammetry (CV) curves with characteristic redox peaks indicated the pseudocapacitive charge storage mechanism of the electrodes. From the discharge curves at 0.4 mA/cm2 and 1.6 A/g constant current densities, the electrode showed areal specific capacitance of 17 mF/cm2 and specific capacitance of 69 F/g, respectively. Cyclic stability was tested by performing 30,000 galvanostatic charge–discharge (GCD) cycles and the electrode exhibited 65% capacitance retention, showing its excellent electrochemical performance and ultra-long cycle life. The excellent electrochemical electrode properties are attributed to the unique processing technique, optimum processing parameters, improved conductivity due to the presence of rGO, and highly porous morphology which offers a high specific surface area. The novel photonic processing we report allows for high-temperature heating of the precursor films achieved via non-radiative recombination of photogenerated electron holes pairs during irradiation. Such extremely quick (ms) heating followed by instantaneous cooling results in the formation of a dense and robust bottom layer of the electrode, resulting in a long cycle life.

We report the preparation of flexible and nano-porous iron oxide-reduced graphitic oxide (Fe2O3–rGO) electrodes using a novel photonic processing method. Due to this unique technique, high-temperature thermal processing could be accomplished on inexpensive and low-temperature substrates instantaneously as opposed to longer processing times of conventional thermal processing. The nano-porous morphology of the electrode not only accommodates the volume changes of the electrode but also facilitates the transport of the electrolyte ions into the electrodes. The as-prepared electrode showed excellent electrochemical performance with an initial specific capacitance of 179 F/g at 2 A/g. Moreover, it exhibited excellent specific capacitance retention after 5000 cycles (70%), revealing its superior cyclic stability. Along with having specific capacitance comparable to that of rigid electrodes, the as-prepared electrode is bendable and lightweight, signifying its potential application in foldable and wearable consumer electronic devices which require continuous energy supply while going through physical deformation. Graphic abstract