Oscillations may cause both economic and technical problems such as a reduction in overall system reliability. Therefore, detecting and preventing oscillatory behavior that affects power systems is important. This paper proposes an oscillation recognition method that includes monitoring and extracting features in a recursive and sequential manner in a time-series measurement in power systems. We propose a geometric feature extraction process for recognizing oscillations by constructing an average system and Poincaré map for time-series measurement. The proposed process provides the features of a system's damping and frequency of oscillation, and the developed monitoring systems are based on nonlinear dynamics. The circulating oscillatory behavior is represented on a finite-integer-delay embedded time-series plane, extracted by a Poincaré map construction, and examined directly along the trajectory to monitor the features of the oscillation according to damping and frequency. Oscillatory behavior recognition is tested on IEEE's second benchmark system for subsynchronous resonance to verify the fast extraction of oscillation components. In addition, a case study for Korean power systems with a high penetration of renewable energy and application on actual measurement data is carried out to demonstrate the practical application of the process.

This study analyzed the impact of varying the momentary cessation (MC) voltage level on the short circuit current of inverter-based resources (IBRs). To analyze the impact of the IBR MC function on the short circuit current, this paper proposes an advanced IBR model for fault current calculation to reflect its fault characteristics and a scheme for analyzing the influence of MC on the short circuit current. Based on the proposed methods, the authors conducted case studies using planning data from the Korea Electric Power Corporation (KEPCO). The influence of MC was investigated on the IBRs located at the southwest side of the KEPCO systems by screening the fault currents while varying the MC voltage. This paper demonstrates that the minimum MC voltage level needed for the fault current not to exceed the circuit breaker (CB) capacity can be proposed through analyzing the impact of MC voltage level on the short circuit current. The test results based on the proposed scheme showed that the short circuit current to power systems could not violate CB capacity if IBRs adjusted the MC voltage level higher than the lowest MC voltage level.

There is a global focus on adding renewable energy sources to the mix of energy supplies. In this study, the grid connections for large-scale offshore wind farms in areas that have high penetration of renewable energy sources were examined. System strength evaluation considering the interaction of wind farms and inverter-based resources (IBRs) was performed; the fault current was then analyzed to determine their contribution to the total fault current at a bus level. These studies revealed that the interaction between offshore wind farms and IBRs may make the power system weaker, and it is possible that fault current contributions from offshore wind farms can violate the capacity limit of existing circuit breakers. The results of steady-state analysis were verified through case studies focused on the southwest area of the Korea Electric Power Corporation (KEPCO) system where large-scale offshore wind farms are planned to be established and connected. Power system planners will benefit from the results of this study with a better understanding of the factors to consider when integrating large-scale wind farms in areas with high penetration of renewables.

System strength is an important concept in the integration of renewable energy sources (RESs). However, evaluating system strength is becoming more ambiguous due to the interaction of RESs. This paper proposes a novel scheme to define the actual interaction boundaries of RESs using the power flow tracing strategy. Based on the proposed method, the interaction boundaries of RESs were identified at the southwest side of Korea Electric Power Corporation (KEPCO) systems. The test results show that the proposed approach always provides the identical interaction boundaries of RESs in KEPCO systems, compared to the Electric Reliability Council of Texas (ERCOT) method. The consistent boundaries could be a guideline for power-system planners to assess more accurate system strength, considering the actual interactions of the RESs.

Measurement-based technology has been developed in the area of power transmission systems with phasor measurement units (PMU). Using high-resolution PMU data, the oscillatory behavior of power systems from general electromagnetic oscillations to sub-synchronous resonances can be observed. Studying oscillations in power systems is important to obtain information about the orbital stability of the system. Floquet multipliers calculation is based on a mathematical model to determine the orbital stability of a system with the existence of stable or unstable periodic solutions. In this paper, we have developed a model-free method to estimate Floquet multipliers using time series data. A comparative study between calculated and estimated Floquet multipliers has been performed to validate the proposed method. The results are provided for a sample three-bus power system network and the system integrated with a doubly fed induction generator.