Peripheral nerve repair is still one of the major clinical challenges which has received a great deal of attention. Nerve tissue engineering is a novel treatment approach that provides a permissive environment for neural cells to overcome the constraints of repair. Conductivity and interconnected porosity are two required characteristics for a scaffold to be effective in nerve regeneration. In this study, we aimed to fabricate a conductive scaffold with controlled porosity using polycaprolactone (PCL) and chitosan (Chit), FDA approved materials for the use in implantable medical devices. A novel method of using tetrakis (hydroxymethyl) phosphonium chloride (THPC) and formaldehyde was applied for in situ synthesis of gold nanoparticles (AuNPs) on the scaffolds. In order to achieve desirable porosity, different percentage of polyethylene oxide (PEO) was used as sacrificial fiber. Fourier transform infrared spectroscopy (FTIR) and field emission scanning electron microscopy (FE-SEM) results demonstrated the complete removing of PEO from the scaffolds after washing and construction of interconnected porosities, respectively. Elemental and electrical analysis revealed the successful synthesis of AuNPs with uniform distribution and small average diameter on the PCL/Chit scaffold. Contact angle measurements showed the effect of porosity on hydrophilic properties of the scaffolds, where the porosity of 75–80% remarkably improved surface hydrophilicity. Finally, the effect of conductive nanofibrous scaffold on Schwann cells morphology and vaibility was investigated using FE-SEM and MTT assay, respectively. The results showed that these conductive scaffolds had no cytotoxic effect and support the spindle-shaped morphology of cells with elongated process which are typical of Schwann cell cultures.

Wound care has been a challenging subject for medical teams and researchers. Bacterial infections are one of the most serious complications in injured skins that often affect healing process. Antibacterial wound dressings can be used to facilitate wound healing process. The purpose of this study is to fabricate chitosan (Chito)/polyethylene glycol (PEG) antibacterial wound dressing doped with minocycline, and to evaluate the influence of composition ratio on the blending properties of the films. To improve the mechanical properties of these films, we examined various amounts of glycerol as a plasticizer. Moreover, we investigated morphological and mechanical aspects, water uptake, degradation, water vapor transmission and wettability properties of the films prepared with various ratios of Chito/PEG/Gly. Assessment of mechanical properties revealed that film containing 80:20 ratio Chito/PEG with 40 PHR Gly content exhibits the highest ultimate tensile strength and elongation at break (9.74 MPa and 45.73% respectively). Furthermore, results demonstrated that upon increasing PEG and Gly contents, degradability and hydrophilicity of the films increased whereas water uptake decreased. Water vapor transmission rate of the films was close to the range of 530–1200 g/m2d, indicating that the as formed films are possible candidates for dressing low exudate wounds or burns. Minocycline loaded films exhibited a biphasic drug release profile and it was more effective on gram‐positive bacteria than on gram‐negative bacteria. The polymeric film with the highest amount of loaded drug (2%) exhibited insignificant cytotoxicity (88%) against normal fibroblast cell line.