The accelerator effect of amine activators N‐methylimidazole and 4‐vinylaniline (4‐VA) on inverse vulcanization and dynamic covalent polymerization (DCP) has been investigated. The sulfur polymer with self‐activation comonomer 4‐VA could also be used for low temperature DCP to incorporate some volatile monomers. Those approaches provide a new synthetic and rate accelerated processes to activate S8 for copolymerization processes with functional comonomers at lower temperatures and under a broader range of reaction conditions.
Electrocatalytic [FeFe]-hydrogenase mimics for the hydrogen evolution reaction (HER) generally suffer from low activity, high overpotential, aggregation, oxygen sensitivity, and low solubility in water. By using atom-transfer radical polymerization (ATRP), a new class of [FeFe]-metallopolymers with precise molar mass, defined composition, and low polydispersity, has been prepared. The synthetic methodology introduced here allows facile variation of polymer composition to optimize the [FeFe] solubility, activity, and long-term chemical and aerobic stability. Water soluble functional metallopolymers facilitate electrocatalytic hydrogen production in neutral water with loadings as low as 2 ppm and operate at rates an order of magnitude faster than hydrogenases (2.5×10 s ), and with low overpotential requirement. Furthermore, unlike the hydrogenases, these systems are insensitive to oxygen during catalysis, with turnover numbers on the order of 40 000 under both anaerobic and aerobic conditions.
We report on the first synthesis of a heterostructured semiconductor tetrapod from CdSe@CdS that carries a single dipolar nanoparticle tip from a core-shell colloid of Au@Co. A four-step colloidal total synthesis was developed, where the key step in the synthesis was the selective deposition of a single AuNP tip onto a CdSe@CdS tetrapod under UV-irradiation. Synthetic accessibility to this dipolar heterostructured tetrapod enabled the use of these as colloidal monomers to form colloidal polymers that carry the semiconductor tetrapod as a side chain group attached to the CoNP colloidal polymer main chain. The current report details a number of novel discoveries on the selective synthesis of an asymmetric heterostructured tetrapod that is capable of 1D dipolar assembly into colloidal polymers that carry tetrapods as side chain groups that mimic "giant tert-butyl groups".
Conduction and valence band energies (ECB, EVB) for CdSe nanorods (NRs) functionalized with Au nanoparticle (NP) tips are reported here, referenced to the vacuum scale. We use (a) UV photoemission spectroscopy (UPS) to measure EVB for NR films, utilizing advanced approaches to secondary electron background correction, satellite removal to enhance spectral contrast, and correction for shifts in local vacuum levels; and (b) waveguide-based spectroelectrochemistry to measure ECB from onset potentials for electron injection into NR films tethered to ITO. For untipped CdSe NRs, both approaches show EVB = 5.9-6.1 eV and ECB = 4.1-4.3 eV. Addition of Au tips alters the NR band edge energies and introduces midgap states, in ways that are predicted to influence the efficiency of these nanomaterials as photoelectrocatalysts. UPS results show that Au tipping shifts EVB closer to vacuum by up to 0.4 eV, shifts the apparent Fermi energy toward the middle of the band gap, and introduces additional states above EVB. Spectroelectrochemical results confirm these trends: Au tipping shifts ECB closer to vacuum, by 0.4-0.6 eV, and introduces midgap states below ECB, which are assigned as metal-semiconductor interface (MSI) states. Characterization of these band edge energies and understanding the origins of MSI states is needed to design energy conversion systems with proper band alignment between the light absorbing NR, the NP catalyst, and solution electron donors and acceptors. The complementary characterization protocols presented here should be applicable to a wide variety of thin films of heterogeneous photoactive nanomaterials, aiding in the identification of the most promising material combinations for photoelectrochemical energy conversion.
We report on noble metal tipping of heterostructured nanocrystals (NCs) of CdSe@CdS tetrapods (TPs) as a chemical reaction to manifest energetic differences between type I and quasi-type II heterojunctions. The energetics between zincblende (ZB) CdSe seed and wurtzite CdS TP arms has previously been probed primarily using ultrafast spectroscopic methods. However, to interrogate the energetics of CdSe@CdS TPs from both larger and very small ZB CdSe seeds (i.e., effective diameters (Deff) 6.2 to 1.8 nm) we utilize the photodeposition of gold nanoparticles as a facile and selective chemical reaction to correlate reaction rates with tetrapod energetics. We observe a 20-fold enhancement in the rate of selective photodeposition of a single AuNP tip onto this series of TPs, which were attributed to straddling of type I vs. quasi-type II energetics as a direct consequence of varying ZB CdSe seed size. Synthetic access to type I and quasi-type II TPs enabled the synthesis of singly tipped AuNP-CdSe@CdS TPs in gram quantities, which is the largest scale synthesis of metal–semiconductor Janus nanoparticles to date
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.