Structurally precision graphene nanoribbons (GNRs) are promising candidates for next-generation nanoelectronics due to their intriguing and tunable electronic structures. GNRs with hybrid edge structures often confer them unique geometries associated with exotic physicochemical properties. Herein, a novel type of cove-edged GNRs with periodic short zigzag-edge segments is demonstrated. The bandgap of this GNR family can be tuned using an interplay between the length of the zigzag segments and the distance of two adjacent cove units along the opposite edges, which can be converted from semiconducting to nearly metallic. A family member with periodic cove-zigzag edges based on N=6 zigzag-edged GNR, namely 6-CZGNR-(2,1), is successfully synthesized in solution through the Scholl reaction of a unique snake-like polymer precursor (10) that is achieved by the Yamamoto coupling of a structurally flexible S-shaped phenanthrene-based monomer (1). The efficiency of cyclodehydrogenation of polymer 10 toward 6-CZGNR-(2,1) is validated by FT-IR, Raman and UV-Vis spectroscopies, as well as by the study of two representative model compounds (2 and 3). Remarkably, the resultant 6-CZGNR-(2,1) exhibits an extended and broad absorption in the nearinfrared region with a record narrow optical bandgap of 0.99 eV among the reported solution-synthesized GNRs. Moreover, 6-CZGNR-(2,1) exhibits a high macroscopic carrier mobility of ~20 cm 2 V -1 s -1 determined by terahertz spectroscopy, primarily due to the intrinsically small effective mass (m*e=m*h=0.17 m0), rendering this GNR a promising candidate for nanoelectronics. ASSOCIATED CONTENT Supporting Information.The Supporting Information is available free of charge at http://pubs.acs.org. Synthetic procedures and characterization data, additional optical, FTIR and Raman spectra of model compounds, STM and AFM characterizations, Solid-state NMR analysis, DFT calculation details, Terahertz spectroscopy, and NMR and mass spectra of new compounds (PDF).

The effect of the Au crystalline plane on the adsorption of different thiols and selenols is studied via reductive desorption (RD) and X-ray photoelectron spectroscopy (XPS) measurements. Self-assembled monolayers (SAMs) using aliphatic (ATs) and aromatic thiols (ArTs) on both Au(111) and Au(100) were prepared. The electrochemical stability of these SAMs on both surfaces is evaluated by comparing the position of the RD peaks. The longer the AT chain the more stable the SAM on Au(100) when compared to Au(111). By means of XPS measurements, we determine that the binding energy (BE) of the S 2p signal corresponding to the S atoms at the thiol/Au interface, commonly assigned at 162.0 eV, shifts 0.2 eV from Au(111) to Au(100) for SAMs prepared using thiols with the C* (C atom bonded to S) in sp hybridization, such as ATs. However, when the thiol presents the C* with an sp hybridization, such as in the case of ArTs, the BE remains at 162.0 eV regardless of the surface plane. Selenol-based SAMs were characterized comparatively on both Au(100) and Au(111). Our results show that selenol SAMs become even more electrochemically stable on Au(100) with respect to Au(111) than the analogue sulfur-based SAM. According to our results, we suggest that the electronic distribution around the Au-S/Se bond could be responsible for the different structural arrangements reported in the literature (gold adatoms, etc.), which should be dependent on the crystalline face (Au(hkl)-S) and the chemical nature of the environment of the adsorbates (sp-C* vs sp-C* and Au-SR vs Au-SeR).

A Scanning Tunneling Microscope (STM) is used to induce a reversible transition between different polymorphs in a binary supramolecular network at the liquid/solid interface. The transition is driven externally by switching the polarity of the sample by positive or negative sample bias potentials. We demonstrate that by mixing bias-sensitive and non-sensitive molecules, we gain access to a variety of binary porous structures that can be prepared and reliably actuated for each relative concentration.

We show that homogeneously mixed self-assembled monolayers (SAMs) of mercaptoalkanoic acids of different chain lengths can be used to build up a pH-sensitive supramolecular switch. The acids with short and long alkyl chains interact via the strong hydrogen bond between carboxylic acid groups. The pH acts as a trigger by breaking or restoring the hydrogen bond interaction in basic or acidic solutions, respectively. The corresponding changes in the monolayer structure were determined by ellipsometry, surface-enhanced Raman spectroscopy, and contact angle measurements. Density functional theory (DFT) calculations were performed to elucidate the structures of interacting molecules compatible with the surface coverage obtained from electrochemical reductive desorption experiments. The simplicity of the preparation procedure assures a high reproducibility whereas the stability of the homogeneous mixed SAM guarantees the reversibility of the switching process.