The double-chained, zwitterionic phospholipid 1,2-dilauroyl-sn-phosphatidylcholine (DLPC, C12) was investigated for its use as a wall coating for the prevention of protein adsorption in capillary electrophoresis. DLPC forms a semipermanent coating at the capillary wall, which allows excess phospholipid to be removed from the capillary prior to electrophoretic separation. A DLPC-coated capillary allowed for the separation of both cationic and anionic proteins with efficiencies as high as 1.4 million plates/m. Migration time reproducibility was less than 1.3% RSD from run to run and less than 4.0% RSD from day to day. Protein recovery was as high as 93%. Cationic and anionic proteins could be separated over a pH range of 3-10, all yielding good efficiencies (N up to 1 million plates/m). The chain length of the phospholipid affected the performance of the wall coating. The C10 analogue of DLPC (DDPC) did not form a coating on the capillary wall while the C14 analogue of DLPC (DMPC) formed a stable coating that prevented protein adsorption to the same extent as its C12 counterpart.

The double-chained cationic surfactant didodecyldimethylammonium bromide (DDAB) was found to form more stable coatings onto the walls of CE capillaries than similar single-chained surfactants such as cetyltrimethylammonium bromide (C16TAB). After removing DDAB from the buffer, the reversed EOF decreased only 3% over 75 min under continuous electrophoretic conditions. Also, the reversed EOF is 60% greater for DDAB than for C16TAB at pH 2. This greater coating stability is associated with a different aggregate structure for the surfactant at the capillary surface. The more homogeneous coating and greater surface coverage provided by DDAB allows the excess surfactant to be flushed from the capillary prior to performing electrophoretic separations. Separations of a basic protein mixture yielded quantitative recoveries, efficiencies ranging from 560,000 to 750,000 plates/m, and migration time reproducibility of 0.8-1.0% RSD (n = 10). This performance is similar to that of adsorbed cationic polymers (Polybrene, polyethyleneimine) but is achieved using a coating procedure that is over 10 times faster.

This paper describes the adsorption mechanisms and aggregation properties of cetyltrimethylammonium bromide (CTAB) and didodecyldimethylammonium bromide (DDAB) surfactants that are used for dynamic coatings in capillary electrophoresis (CE). Atomic force microscopy is used to directly visualize surfactant adsorption on fused silica. It was found that the single-chained surfactant CTAB forms spherical aggregates on silica while the double-chained surfactant DDAB forms a bilayer. Aggregation at the surface occurs at approximately the same surfactant concentration in which EOF reversal is observed in CE. The nearest-neighbor distance between CTAB aggregates varies inversely with buffer pH and becomes constant at the point when the silanol groups are fully ionized. DDAB forms a flat, uniform coating independent of pH. Increasing the buffer ionic strength changes the morphology of the CTAB aggregates from spherical to cylindrical. The change in morphology can alter the surface coverage, which is related to the "normalized" EOF measured in identical buffers. The morphology of a surfactant coating is also shown to affect its ability to inhibit protein adsorption to the capillary wall. Specifically, the full surface coverage provided by DDAB proved superior in a head-to-head comparison with CTAB.

No abstract

The zwitterionic surfactant Rewoteric AM CAS U forms a dynamic wall coating that prevents the adsorption of cationic proteins as well as suppresses the electroosmotic flow (EOF). Addition of polarizable anions to buffers containing this zwitterionic surfactant increases the once suppressed EOF to values nearing +3 x 10(-4) cm2/(V s). The retention of the EOF allows for the separation of analytes of widely different mobilities and is demonstrated by the simultaneous separation of cationic and anionic proteins. Using a buffer containing optimal amounts of the polarizable anion perchlorate and surfactant CAS U, the proteins lysozyme, ribonuclease A, alpha-chymotrypsinogen A, and myoglobin are separated in less than 15 min. Efficiencies as high as 1.5 million plates/m and recoveries greater than 91% are observed for proteins injected in distilled water. Migration time reproducibility is approximately 1% RSD within 1 day and approximately 3% RSD from day to day. The anionic and cationic proteins can be separated over a pH range of 5.5-9, all yielding good efficiencies.