We study incipient motion of single beads on regular substrates made of spherical particles of a different size in steady shear flow at small particle Reynolds numbers. We cover a large range of sizes: from small beads that are highly shielded from the shear flow by the substrate spheres, and hence, are susceptible to the flow through the interstices of the substrate, to beads fully exposed to the flow, where the substrate rather acts like roughness of an otherwise flat surface. Numerical and experimental studies agree within measurement uncertainty. To describe the findings, we extend a recently derived model for particles of equal size which was validated over a wide range of substrates [Agudo et al., “Shear-induced incipient motion of a single sphere on uniform substrates at low particle Reynolds numbers,” J. Fluid Mech. 825, 284–314 (2017)]. The extended model covers the entire spectrum of size ratios, where the critical Shields number varies from about zero to infinity. The model properly describes the numerical and experimental data. For well exposed beads, we find a scaling law between the critical Shields number and the size ratio between mobile bead and substrate spheres with an exponent of −1.

We report a numerical investigation of the structural properties of very large three-dimensional heaps of particles produced by ballistic deposition from extended circular dropping areas. Very large heaps are found to contain three new geometrical characteristics not observed before: they may have two external angles of repose, an internal angle of repose, and four distinct packing fraction (density) regions. Such characteristics are shown to be directly correlated with the size of the dropping zone. In addition, we also describe how noise during the deposition affects the final heap structure.

This paper reports a detailed numerical investigation of the geometrical and structural properties of three-dimensional heaps of particles. Our goal is the characterization of very large heaps produced by ballistic deposition from extended circular dropping areas. First, we provide an in-depth study of the formation of monodisperse heaps of particles. We find very large heaps to contain three new geometrical characteristics: they may display two external angles of repose, one internal angle of repose, and four distinct packing fraction (density) regions. Such features are found to be directly connected with the size of the dropping zone. We derive a differential equation describing the boundary of an unexpected triangular packing fraction zone formed under the dropping area. We investigate the impact that noise during the deposition has on the final heap structure. In addition, we perform two complementary experiments designed to test the robustness of the novel features found. The first experiment considers changes due to polydispersity. The second checks what happens when letting the extended dropping zone to become a point-like source of particles, the more common type of source.

We investigate the residual distribution of structural defects in very tall packings of disks deposited randomly in large channels. By performing simulations involving the sedimentation of up to 50 × 109 particles we find all deposits to consistently show a non-zero residual density of defects obeying a characteristic power-law as a function of the channel width. This remarkable finding corrects the widespread belief that the density of defects should vanish algebraically with growing height. A non-zero residual density of defects implies a type of long-range spatial order in the packing, as opposed to only local ordering. In addition, we find deposits of particles to involve considerably less randomness than generally presumed.

No abstract