No abstract

There is a lack of published research on the economic effect and the risk associated with sand and dust storms (SDS) worldwide. The objectives of this study are to estimate the economic impact of SDS on the oil and gas industry in Kuwait, to estimate a risk index for each loss, and to recommend a sustainable system for the mitigation of the damaging effects and economic losses of infrastructures. Hot spots of wind erosion, wind corridors, and dust frequency and severity formed the basis to locate the most susceptible oil and gas fields and operations. Ten sectors with potential loss vulnerabilities were evaluated: exploration, drilling, production, gas, marine, soil remediation, project management, water handling, maintenance, and research and development. Sand encroachment, although not a sector per se, was also considered. The results indicate that sand, and to lesser extent dust, are damaging and costly to the oil and gas infrastructure of Kuwait, with an economic cost estimation of US$9.36 million, a total of 5159 nonproductive lost hours, and 347,310 m3 of annual sand removal. A risk assessment identified three sectors with the highest risk indices (RI): drilling (RI = 25), project management (RI = 20), and maintenance (RI = 16). Sand encroachment also constituted a high risk (RI = 25). Mitigation of sand storms using a hybrid biological–mechanical system was shown to be cost-effective with an equivalent saving of 4.6 years of sand encroachment. The hazard implications of sand storm events continue to be a major concern for policy-makers given their detrimental economic impacts, and require that government officials wisely allocate investment budgets to effectively control and mitigate their damaging effects.

Accelerated weathering test was performed on blends of linear low density polyethylene (LLDPE) and plastic film waste constituting the following percentages of polyolefin polymers (wt.%): LLDPE (46%), low density polyethylene (LDPE, 51%), high density polyethylene (HDPE, 1%), and polypropylene (PP, 2%). Compounded blends were evaluated for their mechanical and physical (optical) properties. The impact of photodegradation on the formulated blends was studied, and loss of mechanical integrity was apparent with respect to both the exposure duration to weathering and waste content. The effect of processing conditions, namely, the die head temperature (DHT) of the blown-film assembly used, was investigated in this work. It was witnessed that surpassing the melting point of the blends constituting polymers did not always result in a synergistic behaviour between polymers. This was suspected to be due to the loss of amorphous region that polyolefin polymers get subjected to with UV exposure under weathering conditions and the effect of the plastic waste constituents. The total change in colour (ΔE) did not change with respect to DHT or waste content due to rapid change degradation on the material’s surface. Haze (%) and light transmission (%) decreased with the increase in waste content which was attributed to lack of miscibility between constituting polymers.

No abstract

This study deals with the vegetation change in Kuwait from 1974 compared to recent vegetation map and their capabilities on trapping mobile sand, dust and carbon dioxides (Co 2 ). The average cost of one cubic meter removal of encroached sand around infrastructures in Kuwait is 1.32 USD. The capability of trapping sand is much higher for Haloxylon sp. than Stipagrostis sp. by 100%. The areas that were covered by Haloxylon in 1974 lose recently 4385 km 2 for the benefits of Stipagrostis causing the formation of a new mobile sand corridor. The total estimated annual cost for the vegetation change is 35,429,379 USD obtained from the costs of sand encroachment, CO 2 consumption loss and solar energy efficiency loss. Rehabilitation for areas that were occupied with large size canopy vegetation will surely cause a decrease in the aeolian activities and air temperature, lower the albedo and increase the precipitation and solar energy production.