Water is life and every living thing depends on it for existence. Sachet water has gradually become the most widely consumed liquid in Nigeria with varying qualities. This study investigates the temporal variation in water quality of Sachet water produced in Ogbomoso, Oyo State. Ten (10) brands of sachet water from Ogbomoso South and North Local government area were collected within 24 hours of production and stored at standard room temperature and conditions. Sub-samples were drawn from the stock samples on daily basis for physico-chemical measurements on the water samples Temperature, pH, colour, turbidity, Hardness, Total Alkalinity, Dissolve Oxygen (DO), Biological Oxygen Demand (BOD), Electrical Conductivity (EC) and Nitrate values were determined in accordance with World Health Organization (W.H.O) analytical methods. Temperature, pH and Colour values ranged from (28.3 - 30.5) ̊C, (7.96 - 8.80) and (20-70) Hazen, respectively. The Total hardness EC and DO and BOD values varied from (45-105)mg/l, (11 - 184)µs, (2.83 - 12.24)mg/L and (18.2 - 28.4)mg/l, respectively. Shelf life for the selected sachet water in Ogbomoso is 12 weeks from the date of production under laboratory condition with partial exposure to sunlight.

The menace of wastewater pollution in the 21st century is becoming alarming. Application of the low-cost adsorbents for wastewater treatment has received more attention this moment in environmental history than never. Most industrial wastewater has not been receiving adequate treatment prior to disposal into the nearby stream, and this is a potential threat to plants and animals feeding therefrom. There is therefore the need to proffer an effective solution to this pollution problem. An approach of bioremediation with a cost-effective plant waste is considered apt, with the application of Azadirachta indica (Neem tree) bark as adsorbent in this study. Galvanizing/wire-gauze industrial wastewater effluents were collected and subjected to Atomic Absorption Spectrophotometry (AAS) analysis to determine the concentrations of heavy metals. Phytochemical and Proximate analyses of the adsorbent were performed while adsorption study with the effects of adsorbent dosage, contact time, stirring speed and pH on the adsorption process during the wastewater treatment was carried out. The adsorption isotherms and kinetic models that best described the adsorption of Pb 4+ and Cr 3+ were established.

The study aims to determine the runoff depth using Soil Conservation Service Curve Number (SCS-CN) method in Geographical Information System (GIS) environment. For River Asa Watershed, the SCS Curve Number method has been adopted for estimating the runoff depth using Rainfall data from 1987-2018. Land use and change cover map were used for the classification of soil type, in order to determine the Hydrological Soil Group (HSG) using ArcGIS. The runoff was estimated from the rainfall runoff equation. The Antecedent Moisture Condition (AMC), potential maximum retention(s) and initial abstraction were computed. Thematic maps such as Soil and Land Use / Land cover and have been used in conjunction with hydrological data for determining hydrological soil Group (HSG) and Curve Number (CN) for land used and change cover classes over the watershed. The values of Hydrological Soil Group, Curve Number and Annual runoff depth varied (6.28-914.22) km2, (65-100) and (16.50-144.89) × 106 m3. The study shows that the high runoff depth was observed in Hydrological soil group (HSG), when compared with curve number (CN), this is due to dense vegetation cover.

Pozzolans are siliceous or aluminous materials which possess little or no cementing property but chemically react with calcium hydroxide at ordinary temperature to form compounds possessing cementitious properties. There is paucity of information on the pozzolanicity of Cocoa Pod Ash (CPA). Hence, this study investigated the pozzolanicity of CPA. Cocoa pods were obtained from selected farms in Egba Odeda, Ogun State Nigeria. The Cocoa pods were washed, sundried and calcinated to ashes in a furnace between 600° C to 1000° C at Science Laboratory Technology Department, Federal Polytechnic Ilaro, Ogun State. Chemical analyses and X-ray Crystallography were carried out on the CPA to determine the types of oxides present and their varying percentages. The oxides were Silica (SiO,), Ferric (Fe,O,), combined percentages of Ferric and Aluminum oxides (Fe,O, and Al,O,), Calcium (CaO), Magnesium (MgO) and Sulphur (SO,). The moisture content and the Loss of Ignition (LOD) of the CPA samples were also determined.The oxides of Silicon, Ferric, Aluminium, Calcium and Magnesium oxide ranged between 6.39-8.00; 0.78 – 0.89; 1.74- 2,29; 7.15-8.42 and 4.38-5.16% respectively. Sulphur trioxide and LOI ranged 3.51- 3.78 and 27.2- 32.0%, respectively. The Xray crystallography showed that the total percentage composition of SiO, Al,O, and Fe,O, in CPA varied from 14.87-24.21%. The study showed that CPA did not satisfy the minimum 70% requirements stipulated by ASTM C618 (2005) for a pozzolan after the analysis of the oxides but it satisfied all the requirements for LOI, hence CPA is a weak pozzolan