The catalytic sites of acidic zeolite are profoundly altered by the presence of water changing the nature of the Brønsted acid site. High-resolution solid-state NMR spectroscopy shows water interacting with zeolite Brønsted acid sites, converting them to hydrated hydronium ions over a wide range of temperature and thermodynamic activity of water. A signal at 9 ppm was observed at loadings of 2–9 water molecules per Brønsted acid site and is assigned to hydrated hydronium ions on the basis of the evolution of the signal with increasing water content, chemical shift calculations, and the direct comparison with HClO4 in water. The intensity of 1H–29Si cross-polarization signal first increased and then decreased with increasing water chemical potential. This indicates that hydrogen bonds between water molecules and the tetrahedrally coordinated aluminum in the zeolite lattice weaken with the formation of hydronium ion–water clusters and increase the mobility of protons. DFT-based ab initio molecular dynamics studies at multiple temperatures and water concentrations agree well with this interpretation. Above 140 °C, however, fast proton exchange between bridging hydroxyl groups and water occurs even in the presence of only one water molecule per acid site.

Sustainable energy generation calls for a shift away from centralized, high-temperature, energy-intensive processes to decentralized, low-temperature conversions that can be powered by electricity produced from renewable sources. Electrocatalytic conversion of biomass-derived feedstocks would allow carbon recycling of distributed, energy-poor resources in the absence of sinks and sources of high-grade heat. Selective, efficient electrocatalysts that operate at low temperatures are needed for electrocatalytic hydrogenation (ECH) to upgrade the feedstocks. For effective generation of energy-dense chemicals and fuels, two design criteria must be met: (i) a high H:C ratio via ECH to allow for high-quality fuels and blends and (ii) a lower O:C ratio in the target molecules via electrochemical decarboxylation/deoxygenation to improve the stability of fuels and chemicals. The goal of this review is to determine whether the following questions have been sufficiently answered in the open literature, and if not, what additional information is required: What organic functionalities are accessible for electrocatalytic hydrogenation under a set of reaction conditions? How do substitutions and functionalities impact the activity and selectivity of ECH? What material properties cause an electrocatalyst to be active for ECH? Can general trends in ECH be formulated based on the type of electrocatalyst? What are the impacts of reaction conditions (electrolyte concentration, pH, operating potential) and reactor types?

No abstract

Electrocatalytic hydrogenation is increasingly studied as an alternative to integrate the use of recycled carbon feedstocks with renewable energy sources. However, the abundant empiric observations available have not been correlated with fundamental properties of substrates and catalysts. In this study, we investigated electrocatalytic hydrogenation of a homologues series of carboxylic acids, ketones, phenolics, and aldehydes on a variety of metals (Pd, Rh, Ru, Cu, Ni, Zn, and Co). We found that the rates of carbonyl reduction in aldehydes correlate with the corresponding binding energies between the aldehydes and the metals according to the Sabatier principle. That is, the highest rates are obtained at intermediate binding energies. The rates of H2 evolution that occur in parallel to hydrogenation also correlate with the H-metal binding energies, following the same volcano-type behavior. Within the boundaries of this model (e.g., compounds reactive at room temperature and without important steric effects over the carbonyl group), the reported correlations help to explain the complex trends derived from the experimental observations, allowing for the correlation of rates with binding energies and the differentiation of mechanistic routes.