Nickel‐rich layered oxide cathodes with the composition LiNi1−x−yCoxMnyO2 (NCM, (1−x−y) ≥ 0.6) are under intense scrutiny recently to contend with commercial LiNi0.8Co0.15Al0.05O2 (NCA) for high‐energy‐density batteries for electric vehicles. However, a comprehensive assessment of their electrochemical durability is currently lacking. Herein, two in‐house cathodes, LiNi0.8Co0.15Al0.05O2 and LiNi0.7Co0.15Mn0.15O2, are investigated in a high‐voltage graphite full cell over 1500 charge‐discharge cycles (≈5–10 year service life in vehicles). Despite a lower nickel content, NCM shows more performance deterioration than NCA. Critical underlying degradation processes, including chemical, structural, and mechanical aspects, are analyzed via an arsenal of characterization techniques. Overall, Mn substitution appears far less effective than Al in suppressing active mass dissolution and irreversible phase transitions of the layered oxide cathodes. The active mass dissolution (and crossover) accelerates capacity decline with sustained parasitic reactions on the graphite anode, while the phase transitions are primarily responsible for cell resistance increase and voltage fade. With Al doping, on the other hand, secondary particle pulverization is the more limiting factor for long‐term cyclability compared to Mn. These results establish a fundamental guideline for designing high‐performing Ni‐rich NCM cathodes as a compelling alternative to NCA and other compositions for electric vehicle applications.

A novel paradigm for the design of surfactants for water/CO 2 (W/C) microemulsions is presented. The paradigm focuses on the fractional free volume (FFV) available to CO 2 at the interface. The FFV is an unambiguous geometric parameter that is calculated directly from surfactant tail geometry and surface coverage. We present an analysis of recent experimental studies indicating that low FFV is a necessary, although not sufficient, condition for W/C microemulsion formation and that both microemulsion and macroemulsion stability correlate qualitatively with FFV. This correlation is understood by noting that a decrease in FFV tends to favor the factors that stabilize W/C microemulsions, namely, decreased interfacial tension, reduced overlap between tails (weakening attractive interdroplet interactions), and increased interfacial curvature. These factors are more challenging to achieve in CO 2 than in alkane solvents, implying that low FFV is especially important for W/C microemulsions.

Electrophoretic mobilities of TiO2 colloids in an apolar solvent, toluene, were measured by differential-phase optical coherence tomography (DP-OCT). An electrode spacing of 0.18 mm, made possible by optical coherence tomography with transparent electrodes, enables measurement of the electrophoretic mobility with small samples (20 μL) of highly turbid colloids at low applied electric potential to avoid electrohydrodynamic instability and electrochemical reactions. In the presence of Aerosol-OT reverse micelles, which stabilized the countercharges, the zeta potential was positive for hydrophilic TiO2 (13 mV at 90 mM AOT) and negative for hydrophobic TiO2. The magnitudes of the zeta potentials were very similar for these two types of TiO2 and decreased at the same rate with AOT concentration. For both hydrophilic and hydrophobic TiO2, a general mechanism is presented to describe the zeta potential in terms of preferential partitioning of cations and sulfosuccinate anions between the particle surface and reverse micelle cores in bulk. This preferential partitioning is governed by the hydrophilicities and extents of the particle surfaces and reverse micelle cores, as a function of surfactant and water concentration. The emerging understanding of the complex charging and stabilization mechanisms for colloids in apolar solvents will be highly beneficial for the design of novel materials.

Liquid and supercritical carbon dioxide swell potassium carboxylate perfluoropolyether (PFPE-K) cylindrical micelles in water to produce novel CO(2)-in-water (C/W) microemulsions. The swelling elongates the micelles significantly from 20 to 80 nm as the molar ratio of CO(2) in the micelles to surfactant (R(CO2)) reaches approximately 8. As the micelles swell to form microemulsions, the solubility of pyrene increases by a factor of ca. 10. Fluorescence spectra suggest that pyrene resides primarily in the low-polarity micelle core rather than in the palisade region. The results illustrate the ability of C/W microemulsions to solubilize both lipophilic and fluorophilic substances simultaneously.