In situ high-pressure tensiometry and ab initio calculations were used to rationally design surfactants for the 1,1,1,2-tetrafluoroethane-water (HFA134a|W) interface. Nonbonded pair interaction (binding) energies (E(b)) of the complexes between HFA134a and candidate surfactant tails were used to quantify the HFA-philicity of selected moieties. The interaction between HFA134a and an ether-based tail was shown to be predominantly electrostatic in nature and much more favorable than that between HFA134a and a methyl-based fragment. The interfacial activity of (i) amphiphiles typically found in FDA-approved pressurized metered-dose inhaler (pMDI) formulations, (ii) a series of nonionic surfactants with methylene-based tails, and (iii) a series of nonionic surfactants with ether-based tails was investigated at the HFA134a|W interface using in situ tensiometry. This is the first time that the tension of the surfactant-modified HFA134a|W interface has been reported in the literature. The ether-based surfactants were shown to be very interfacially active, with tension decreasing by as much as 27 mN.m(-)(1). However, the methyl-based surfactants, including those from FDA-approved formulations, did not exhibit high activity at the HFA134a|W interface. These results are in direct agreement with the E(b) calculations. Significant differences in interfacial activity are noted for surfactants at the 2H,3H-perfluoropentane (HPFP)|water and HFA134a|W interfaces. Care should be taken, therefore, when results from the mimicking solvent (HPFP) are extrapolated to HFA134a-based systems. The results shown here are of relevance in the selection of surfactants capable of forming and stabilizing reverse aqueous aggregates in HFA-based pMDIs, which are promising formulations for the systemic delivery of biomolecules to and through the lungs.

Nanobiotechnology, the bio-branch of nanotechnology is considered to be one of the fastest emerging research fields. Biosynthesis of metallic nanoparticles is currently under exploitation. Use of plant and plant materials for the synthesis of Zinc nanoparticles is relatively new and exciting research field. The biogenic zinc nanoparticles were synthesized using the leaves of Parthenium hysterophorous by green synthesis route. UV-VIS absorption spectroscopy was used to monitor the quantitative formation of zinc nanoparticles. The characteristics of the synthesized zinc nanoparticles were studied using scanning electron microscopy and nanoparticle analyzer. Zinc nanoparticles were observed to be spherical in shape with size range of 16 to 108.5 nm. The measured zeta potentials varied from 100.4 to 117.20 mV indicate high dispersion of the zinc nanoparticles. The synthesized zinc nanoparticles showed good enzymatic activity and microbial activity. The physiological parameters increased from 30 to 60 days of sowing when compared to control.

A combined computational and experimental approach is used to determine the interfacial thermodynamic and structural properties of the liquid 1,1,1,2-tetrafluoroethane (HFA134a)-vapor and liquid HFA134a-water (HFA134a|W) interfaces at 298 K and saturation pressure. Molecular dynamics (MD) computer simulations reveal a stable interface between HFA134a and water. The "10-90" interfacial thickness is comparable with those typically reported for organic-water systems. The interfacial tension of the HFA134a|W interface obtained from the pressure tensor analysis of the MD trajectory is in good agreement with the experimental value determined using in situ high-pressure tensiometry. These results indicate that the potential models utilized are capable of describing the intermolecular interactions between these two fluids. The tension of the HFA134a|W interface is significantly lower than those typically observed for conventional oil-water interfaces and similar to that of the compressed CO(2)-water interface, observed at moderate CO(2) pressures. The MD and tensiometric results are also compared and contrasted with the HFA134a|W and chlorofluorocarbon-water tension values estimated from a parametric relationship. This represents the first report of the interfacial and microscopic properties of the (propellant) hydrofluoroalkanes (HFA)|W interface. The results presented here are of relevance in the design of surfactants capable of forming and stabilizing water-in-HFA microemulsions. Reverse aqueous microemulsions in HFA-based pressurized metered-dose inhalers are candidate formulations for the systemic delivery of biomolecules to and through the lungs.

These swellable hydrogel-based microparticle pMDI formulations could be used as potential delivery vehicles for nanoparticle therapeutics.

No abstract